STEELGREEN SG36 Zero-Turn Sprayer Spreader Instruction Manual

INSTRUCTION MANUAL
STAINLESS STEEL RATE DIAL HOLDER OPTION
Models: SG36, SG42, SG46, & SG52

SG36 Zero-Turn Sprayer Spreader

RATE DIAL HOLDER INSTALL INSTRUCTIONS

STEP ONE: Remove the clip and spinner.
CAUTION!
Be sure the hopper is empty before starting the following steps.

STEP TWO: Set the rate dial to “6” and measure the gate opening .
NOTE: Write down the measurement to be used to install the new dial holder.

NOTE: Holes will need to be drilled in gate frame.
Step 3 is optional, the gate assembly is silicone to the hopper tub. It will have to be re-silicone if removed.
NOTE: If you choose to leave the assembly on the unit, remove the hopper shaft to slide the rate dial holder assembly out.

STEP THREE:

• Disconnect the gate and diffuser cable.
• Remove the (8) bolts and remove the gate assembly from the hopper tub.

WARNING!
If you choose to leave the assembly attached to the tub, place a peace of wood between the frame and hopper tub to keep from drilling through the hopper tub.
STEP FOUR:

• Squeeze the rate dial holder to disconnect it from the gate assembly.
• Slide the rate dial assembly along with the gate out of the frame.

STEP FIVE: Disconnect the gate from the guide.

STEP SIX:

• Insert the guide through the opening of the rate dial provided with the kit.
• Re attach the gate to the guide.

STEP SEVEN: Slide the new rate dial holder assembly into the frame.

STEP EIGHT:

• Set the new rate dial to “6”.
• Mark the holes on the plate using the measurement from step 2.
• Remove the rate dial and gate assembly.
• Drill the holes in the plate.

STEP NINE:

• Re attach the assembly to the hopper tub if it was removed.
  NOTE: Be sure to re-silicone between the rate dial assembly and hopper tub.

• Re connect the gate and diffuser cables.

• Re install the new rate dial holder assembly.

• Attach the rate dial holder assembly to the frame with the (4) 1/4” X 1/2” bolts & (4) 1/4” nylock nuts provided with the kit.

STEP TEN:

• Re attach the hopper shaft if it was removed.
• Re attach the spinner and clip.

MADE IN THE USA
Steel Green Mfg.
824 S State Road 39
Lebanon, IN 46052
(765)-481-2890
www.steelgreenmfg.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>