El Paso Communication Systems T23 4 Channel Transmitter Instructions
- June 6, 2024
- El Paso Communication Systems
Table of Contents
El Paso Communication Systems T23 4 Channel Transmitter Instructions
Description
Each button’s function is the same, saying that one button controls one gate. Work mode: open-stop-close-stop.
Specification
- Frequency: 433.92Mhz
- Button: 4
- Voltage: 6V
- Battery: 160mAh
- Environment: -20-50°C
- Encoded Mode: learning code
- Led: Blue
Applying example of Bisen gate/door opener
-
Transmitter’s code setting
Press “LEARN BUTTON”,the “LEARN LED” light, then, press the button which you choose on the transmitter till the “LEARN LED ” flash and go out, Now, the transmitter is coded. Other transmitters can be coded as this way.
Specification maybe changed without a prior notification. -
Erasing the transimitter’s code
Erasing transmitter codes: Press” LEARN BUTTON”and hold on to make the “LEARN LED”light till go out. Now, all codes of transmitters which had been learnt are cleared.
Mark: “Learn button” and “learn led” are in BISEN control board.
Fcc Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.