Char-Broil Controller Electric Patio Bistro User Manual

WARRANTY PART
REPLACEMENT GUIDE – CONTROLLER

Controller Electric Patio Bistro

NOTE: Some grill parts shown in the assembly steps may differ slightly in appearance from those on your particular grill model. However, the method of assembly remains the same.

Tools Required:

1. Prior to any service, unplug power cord.

2. Remove Warming Rack, Cooking Grates and Emitters.

3. Remove Doors

4. Remove Fascia Screws.

5. Remove side shelf fascia.

6. Remove Control Panel Screws.
   Hold control panel when removing screws to prevent from falling.

7. Pull Control Panel straight out and rotate downward.

8. Unplug wires.
   Tip: Use needle nose pliers to remove valve harness and temp probe wires.
   Hold controller connector while gently wiggling and removing the wire.
   • Press small tab on power cable connector to release connector and pull.
   • Ensure thick ignition wire and ground cable are attached to the locations shown below.

9. Remove controller heat shield and controller. Then replace with new parts.
   Tip: When installing new controller, start two nuts at bottom mounting location, then slide bottom edge of controller under nuts for easier installation.
   Controller heat shield must be reinstalled after controller is set in place .

10. Connect wires. Ensure thick ignition wire and ground cable are attached to the locations shown below.

11. Install Control Panel assembly.
    When reinstalling, ensure ignitor wire is routed over the top of the valve bracket.
    • First, line up valve with burner tubes, pushing right side of control panel in placeas needed to help with alignment.
    • Reach inside firebox to adjust burner tube position as needed. With tubes on valve, slide left side of control panel into place.
    • Finger tighten control panel screws on each side while holding control panel inplace

12. VERY IMPORTANT:
    Burner tubes must r eengage valve openings when placing control panel assembly back on grill.

13. Secure Control Panel and Fascia Screws.

14. Replace Doors14 Replace Doors14 Replace Doors

15. Replace Emitters, Cooking Grates and Warming Rack. IMPORTANT: Infrared emitters must be placed keeping both flat walls overlapped to prevent any flare-up. Inspect your infrared emitter before each use covered with debris. See the Grilling Guide to ensure that the openings are not for detailed cleaning instructions.Align cast iron grate to the infrared emitter as shown.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>