RUGGED RIDGE CJ XHD Front Bumper Standard End Kit Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
CJ XHD Front Bumper Standard End Kit
Installation Guide
CJ XHD Front Bumper Standard End Kit
Components
-
Left Standard End……………….(1)
-
Right Standard End…………….(1)
-
Standard Ends are easier to install with the Center Section of Modular HD Bumper off of the vehicle, but can be installed with the Center Section already installed. If Standard Ends are replacing previously installed Stubby Ends, remove them so that empty ends remain.
-
Position the ends to the ends of the Center Section, aligning the studs in the ends with the holes in the sides of the Center Section. Insert the studs in the Standard End into the holes in the Center Section and secure them with the nuts that came with the Center Section.
-
Once all 6 nuts have been started, tighten them. Installation is now complete!
Congratulations on the purchase and installation of a quality Rugged
Ridge product! Ask your retailer about the following additional accessories to
the JK Modular HD Bumper:
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Copyright © 2022 Omix-Ada® , Inc.
460 HORIZON DR. SUITE 400
SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>