12 North Industries SPBR-02 Ford Bronco Front LCA Skid Plates Instruction Manual
- June 13, 2024
- 12 North Industries
Table of Contents
12 North Industries PRODUCT
INSTALLATION MANUAL
A-Arm Skid Plate
2021+ Bronco
SPBR-02
SPBR-02 Ford Bronco Front LCA Skid Plates
TOOLS REQUIRED
– #5 Allen Head
– 18mm Socket| SKILL LEVEL
– Novice/Intermediate
– 1 persons
Little skill level required, you can easily install it by yourself.| TIME
REQUIRED
– 1 Hour
Time to install this should only take about an hour
---|---|---
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
Before you install this kit — Read and understand all instructions, warnings,
cautions, and notes contained in this installation instruction guide. Consult
your vehicle owner’s manual for proper disconnection of electrical and lifting
of vehicle if required for installation of this product.
This install may require some technical skills and knowledge of basic
mechanical work. If you do not feel that you are capable of performing this
install please take this product to a trained professional.
After reading this guide please contact us with any questions or concerns
before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you or your
vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation. Installation of this kit without proper knowledge of the factory recommended procedures may affect the performance of these components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged and all installation hardware has been included. If parts are missing from kit, please be prepared to provide the following information
- Name of purchase location
- Bar Code on side of box
- Date above bar code
- Date inside box cover
STEP 1
Begin by unpacking all items and inspecting for missing pieces or damage. If
you have any concerns, please contact the company the product was purchased
from.
Hardware Included:
(4) M8x90mm Bolts
(4) M8 Locking Nuts
(8) M8 Flat Washers
STEP 2
For this install, the Bronco needs to have all the weight on the tires/
suspension to ensure shock does not move. Using a 18mm socket, remove both
lower shock bolts. 
STEP 3
Hold up the A-arm skid plate aligning the two studs with the holes on the skid
plate. Loosely install factory hardware onto studs.
STEP 4
Raise the skid plate so the two ears surround each arm of the A-arm near the
center of the vehicle. Using the provided M8 hardware, loosely install bolts
over each arm. 
STEP 5
Tighten factory shock nuts to 93 ft-lbs. Tighten M8 bolts with a #5 allen head
until secure and repeat on opposite side.
Note: If you are running aftermarket shocks, your torque specs may vary.
6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>