CTA PAD-ASKM6 Dual Security Kiosk Stand with Locking Case and Cable Instruction Manual
- June 13, 2024
- CTA
Table of Contents
Dual Security Kiosk Stand with Locking Case and Cable
PAD-ASKM6
INSTRUCTION – MANUAL
CONTENTS:
INSTALLATION:
-
Attaching Holder to Body
1A. Insert holder joint (C) into body joint (B) and align allen key hole.
1B. Screw the allen screw (D) into hole and securely tighten with provied allen tool (F). -
Attaching Body to Base
2A. Insert base joint (A) into body joint (B) andalling allen key hole.
2B. Insert the allen screw (D) into hole and securely tighten with provided allen tool (F). -
(Optional) Attaching Base Pads to Base
3A. Stick adhesive pads (G) to bottom of standbase (A) for scratch protection and temporary mounting. -
Inserting Tablet into Enclosure 4A. Open the case (C) with the stand on a flat surface.
4B. Place your tablet device inside the tray (C).
4C. Close the case door and turn the key (I) clockwise to lock.
**Tablet and cable only shown for illustrationpurposes, not included.
4D. Internal cable
routing.C -
(Optional) Bolting to Countertop
5A. Aling thetwo screws (H) with the holes in the base (A). 5B. Screw in screws until securely attached to counter. -
Cable Management
6A. Fish the cable wire through the top end of the kiosk body (B).
6B. Fish the cable wire out the other end as shown above. -
Adjustability
7A. Adjust the joint rotation to the prefered angle.
7B. Adjust the orientation to the prefered view. -
Security – Cable Lock
8A. Anchor the cable loop of your security cable lock (J) around an immovable object.
8B. Secure and lock the other end to the kiosk (A) into the cable lock slot hole as shown.
36 Taaffe Place Brooklyn, NY 11205
**support@ctadigital.com
888-733-4448
www.ctadigital.com**