DENSO TN0035B Car Audio Stereo Unit Instruction Manual
- June 13, 2024
- DENSO
Table of Contents
(Type A)
TN0035B
Operation Manual
Model name
| Car Audio
---|---
Model No|
TN0035B
1-Rating
RATED VOLTAGE
| 12.0V (10.5～16.0V) – ground
---|---
LOAD IMPEDANCE|
4Ω
BACK UP CURRENT
| 2.1mA or less
RATED CURRENT|
4.0Ａ or less
(Vcc=13.2V, 0.5W output)
AM TUNING RANGE
| 531 – 1602 kHz (9kHz step)
FM TUNING RANGE|
87.5 – 108 MHz (100kHz step)
DAB TUNING RANGE
|
174.928 – 229.072 MHz
2-Button Function Spec
Button No.
| Button Name|
Operation
---|---|---
(1)
|
POWER
| Audio ON/OFF
(2)
|
BACK
| Transition to previous screen
(3)
|
HOME/TALK
| Short Push: Transition to home screen
Long Push: AA/CP voice recognition
(4)
|
VOL DOWN
| Short Push: Decrease Volume Down 1 step
Long Push: Decrease Volume Down continuously
(5)
|
VOL UP
| Short Push: Increase Volume Up 1 step
Long Push: Increase Volume Up continuously
3-Radio operation procedure
[Operation procedure] (1) (ACC-ON)
After the ACC-ON, confirm that Toyota screen is displayed.
(2) “CAUTION”
The screen is changed to “CAUTION” screen after a few seconds. *ACC-ON
Note: It takes a little longer for the first time of ACC-ON.
(3) Press the “Continue” button on the face panel after a few seconds to move MENU screen.
Menu Screen Display
(4) POWER
Press the POWER button.
When the Radio Mode Window on the screen is pressed,”FM1″ screen is displayed.
- Press anywhere in this area
(5) Confirm that the screen is changed as below,
Please push down the “<“button or “>”button.
This will start to SEEK.
- Push this button
※ Same as AM/DAB mode.
4-Operating manual (Bluetooth/Handsfree)
[Operation procedure] (1) (ACC-ON)
After the ACC-ON, confirm that Toyota screen is displayed.
(2) The screen is changed to “CAUTION” screen after a few seconds.
Note: It takes a little longer for the first time of ACC-ON.
(3) Press the “Continue” button on the face panel after a few seconds to move MENU screen.
- Push this button
- Menu Screen Display
(4) Please press the “Setting” button on the face panel to move to Settings screen
- Push this button
(5) Confirm if ”Settings” screen is displayed, select the ”Bluetooth” button on the display.
- Push this button
(6) Please press the ”Add Device” button of the screen
- Push this button
(7) Please press the ”Search Device” button of the screen
- Push this button
(8) Confirm if screen is changed as below,
Please set iPhone or iPod in pairing mode.
※Displays when you have more than one pairing equipment
(9) Select the iPhone or iPod to connect.
※ Operate the phone after the message on the screen
(10) ”Connection Completed” is displayed if completed.
5-FCC Operating manual Requirement
CAUTION: Radio Frequency Radiation Exposure
This equipment complies with FCC radiation exposure limits set forth for
uncontrolled equipment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment has very low levels of RF energy that is deemed to
comply without maximum permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated with at least 20cm and more
between the radiator and person’s body in normal use position.
Co-location: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
DENSO TEN CONFIDENTIAL
Documents / Resources
|
DENSO TN0035B Car Audio Stereo
Unit
[pdf] Instruction Manual
BABTN0035B, TN0035B, TN0035B Car Audio Stereo Unit, Car Audio Stereo Unit,
Audio Stereo Unit, Stereo Unit, Unit
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>