SAFAVIEH FLU4099 Ceiling Light User Manual
- June 13, 2024
- SAFAVIEH
Table of Contents
User Manual
FLU4099 Ceiling Light
Model#: FLU4099
Product Dimensions: 15″L X 15″W X 12″H
WARNING
- WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN **
- Switch off the main electrical supply from the main fuse box / circuit breaker before installation.
- Inspect item carefully before attempting to install.
- If there is any damages or obvious defects, do not install.
- Item may not be returned once it has been installed.
CARE AND MAINTENANCE
- To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the surface of the fixture.
- To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the interior surface of the fixture.
- Do not use any cleaners with chemical, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
NOTICE& IMPORTANT SAFETY INSTRUCTIONS
- Please make sure that you have all parts indicated before you begin assembly of this item
- This item should be assembled on a soft surface to prevent scratching the finish during assembly
- To reduce the risk of fire, electrical shock or injury to persons or property, please follow the guideline below for safe use and installation
- The external flexible cable or cord of this lamp cannot be replaced
If the cord is damaged, the lamp shall be destroyed
Part List and Hardware List
PREPARATION
- Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
- If any part is missing or damaged, do not attempt to assemble the product.
- Estimated Assembly Time: 20 minutes.
- If you are having difficulty, our friendly Customer Care team is always here to help. Please email [email protected]
PLEASUE USE TYPE”B” BULB MAX 40-WATT OR CFL BULB MAX 13-WATT OR LED MAX 9-WATT. THERE ARE 3 X 4W LED BULBS IN THE BOX.
Step 1: Unpack all parts from cartons carefully.
Turn the Canopy Nut (I) counterclockwise to separate the Mounting Plate (A)
and Lamp Body (D)
Step 2: Wire connection
Connect fixture neutral wire (ribbed) to the outlet box neutral wire (usually
white) using a wire nut. Connect fixture hot wire (smooth with markings) to
the outlet box hot wire (usually black) using a wire nut. CAUTION: Do not
reverse the hot and neutral connections
Grounding Instructions:
Wrap ground wire from outlet box around green ground screw on mounting Plate
(A), no less than 2″ from wire end. Tighten ground screw. If fixture is
supplied with a ground wire, connect to outlet ground wire with a wire
connector.
Step 3:
Fix the Mounting Plate(A) to the junction box with Mounting Screw (C). Step 4:
Attach the Lamp Body(D) to the junction box and fix it by turning the Canopy
Nut(I) clockwise.
Step 5:
Insert the bulbs (L) into the Sockets
Step 6: Insert the Shade (E) and Gasket (H) into
the tooth section below the Lamp Body (D) in turn, and fasten it by rotating
the Nut (G) clockwise, Insert the Cover (F) into the tooth section below the
Lamp Body (D) in turn, and fasten it by rotating the Finial (k) clockwise