CTA TV-UVAWM Universal VESA Articulating Wall Mount Instruction Manual

CTA TV-UVAWM Universal VESA Articulating Wall Mount

CONTENTS

INSTALLATION

**BELOW : TOOLS REQUIRED FOR INSTALLATION BUT NOT INCLUDED

Setting up Wall Mount Bracket on Dry Wall

Identify the wall studs and locate where you want to place your mount. Place the wall bracket (A) on the wall and with a level (not included), mark off the location of the drill points as illustrated. Key point is to align any of the holes to the spacing of the studs. Afterwards use a powerdrill (not included) with a 5132″ diameter drill bit, and drill 2″ deep into where was it marked with (3) screws provided (W-A)

Setting up Wall Mount Bracket on Solid Wall

Place the wall bracket (A) on the desired location on the wall and with a level (not included), mark off the location of the drill points as illustrated. Afterwards use a powerdrill (not included) with a 3/8″ diameter drill bit, and drill 2.2· deep where was marked with (3) screws provided (W-A).

Setting Up Your VESA Mount to the Correct Configuration

Identify whether your monitor or TV device has mounting holes in the 200×200 or 200×100 configuration. Arrange the arm pieces in the right configuration. After, take the screws (E) and hex nuts (F) and align them with the holes. Using a screwdriver (Not provided) , rotate in th screws while holding the hex nuts from behind with your hands.

Mounting TV to Wall Brackets

Align your now arranged VESA bracket to the back of your TV I Monitor device (Not Included). Then use the proper combination of screws, washers, nuts as illustrated below based on what VESA configuration you are. Rotate in securely and make sure everything is tight and on right. Find the right image context for your setup below.

Attaching TV/MonitorNESA Setup to Wall Arm

• Identify the connector adapter at the end of the wall arm. There should be a small screw on the edge which you need to first remove with a ffat head screw driver tool (Not included} If it is already removed, then you don’t need to do this step.
• Attach the now combined TV/Monitor and VESA attached setup with the wall arm by slidding the TV/MonitorNESA setup from above onto the end of the wall arm. After, take the small screw and rotate it back on with the flat head screw driver (Not included) until securely fastened.
• Once everything is attached, you can use a small padlock or lock(Not included} as illustrated to secure your monitor/tv from theft.

Cable Routing

Identify the clips on the under belly of the product as illustrated. Take the cord/cable from your device and insert through the clips down towards the last before fishing the wire to the power source or wherever the final plug-in maybe.

Adjustability
Rotate I Turn I Tilt I Angle your mount at various joints to find the optimum desired angle and orientation as required.

• 36 Taaffe Place Brooklyn, NY 11205
• support@ctadigital.com
• 888-733-4448
• www.ctadigital.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>