CTA LT-USBPOSB Laptop Desk Mount with USB Installation Guide
- June 13, 2024
- CTA
Table of Contents
CTA LT-USBPOSB Laptop Desk Mount with USB
CONTENTS
INSTALLATION
Installing Desk Mount Base Platform Components
- 1A. Screw in USB platform (D) to the base (E) tightly using the screws (F) with tool (H), and place the top cover (C) as shown above.
Installing Desk Mount Main Body
- 2A. Screw in the main kiosk body (A) to the assembled platform (C, D, E) with screws (F) from below using the provided allen tool (H) until securely tightened.
Mounting Laptop Holder to VESA Plate
- 3A. Install laptop holder (B) to VESA Base (A) by rotating in the provided screws (F) with washers (K) with the included allen key tool (H) as illustrated above.
How to Setup your Holder
- 4A. Extend the holder brackets.
- 4B. Adjust the holder to your laptop by sliding the brackets towards it.
- 4C. Once laptop is securely in place, tighten four knobs as shown until security fastened.
Powering Up Cooling Fan
- 5A. Locate the fan.
- 5B. Find the integral USB cable below.
- 5C. Plug into your laptop to power the fan.
Cable Management
- 6A. Route all cables through the cable organizer as illustrated.
Cable Management
Fish the cable wire through the top end of the kiosk body and out of the other
end at the bottom of the base.
Contact us
- 36 Taaffe Place Brooklyn, NY 11205
- support@ctadigital.com
- 778-991-0169
- www.ctadigital.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>