CTA LT-DMCGCF Articulating Desk Mount Clamp for Laptops Installation Guide

CTA LT-DMCGCF Articulating Desk Mount Clamp for Laptops

Product Information

The Articulating Desk Mount Clamp for Laptops with Built-In Cooling Fan (model LT-DMCGCF) is a versatile mounting solution for laptops. It is designed to securely hold and cool laptops while providing adjustable positioning options for comfortable viewing angles. The mount comes with a built-in cooling fan to prevent  overheating during prolonged use.

INSTALLATION – MANUAL

CONTENTS

A. Option 1. Clamp Mount Installation

1AA. Rotate in the (3) screws (L) through the base (C) and pole (B) using the allen key tool (Q). Then, rotate in the (3) screws (M) through the component (D) and base (C). At last, adhere the (4) rubber pads (O) to the base (C) as shown by removing the covers.

1AB. If clamping to a 10-55mm surface, rotate in the (2) screws (N) in the top holes of component (D) using the allen key tool (Q). If clamping to a 50-85mm surface, rotate in the (2) screws (N) in the bottom holes of component (D) using the allen key tool (Q). At last, attach the tool holder (F) to component (E) from the back to cover the holes as shown above.

1B. Option 2. Grommet Mount Installation

1BA. Rotate in the (3) screws (M) through the grommet component (H) and base (C) using the allen key tool (Q). Then, adhere the (4) rubber pads (O) to the base (C) as shown by removing the covers.

1BB. Use a pre-dilled surface or drill a hole on the surface as shown above. Insert the grommet component (H) inside the hole. Then, insert through the rod the component (I), then the washer (K) and at last the hex nut (J), and use the included wrench (S) to securely tighten the assembly to the desired surface.

Mounting Arm to Pole

3A. Insert component (P) and (A) through the pole (B). Once in the desired position, rotate the hex screw on component (A) base using the included allen key tool (R) until securely tightened.

Mounting Laptop Holder to VESA Plate

3B. Install the laptop holder (T) to VESA plate (A) by aligning the holes and rotating in the provided screws (U) using the included allen key tool (H) as shown above.

How to Setup your Holder

• Extend the holder brackets
• Adjust the holder to your laptop by sliding the brackets towards it.
• Once laptop is securely in place,] tighten four knobs as shown untilsecurily  fastened.

Powering Up Cooling Fan

• Find the integral USB cable below.
• Plug into your laptop for power

Cable Routing

Using the provided clips, route the wire from your device to the power source as illustrated.

Adjusting Tilt

Adjust to the desired angle, then tighten the screws using the allen key (R) as shown, alternating from each screw as you tighten them.

Adjusting Arm

Documents / Resources

| CTA LT-DMCGCF Articulating Desk Mount Clamp for Laptops [pdf] Installation Guide
LT-DMCGCF, LT-DMCGCF Articulating Desk Mount Clamp for Laptop, Articulating Desk Mount Clamp for Laptop, Desk Mount Clamp for Laptop, Mount Clamp for Laptop, Clamp for Laptop, Laptop
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>