CTA PAD-DMCGHS Counterbalance Tablet Arm with Universal Security Holder Instruction Manual
- June 13, 2024
- CTA
Table of Contents
Counterbalance Monitor Arm
w/ Universal Security Holder
PAD-DMCGHS
INSTRUCTION – MANUAL
PAD-DMCGHS Counterbalance Tablet Arm with Universal Security Holder
CONTENTS:
INSTALLATION:
-
Clamp Mount Installation:
1A. Align pole (C), base (D) and turn in provided screws(M) with allen tool(R). (Shown Above) 1B. Then attach metal L piece (E) with screws (N) with allen tool (R). (Shown Above) 1C. Add adhesive foam pieces (P). (Shown Above)
1D. Align
assembled pole base to clamp (F) and turn in provided screws (O) into working
holes with provided tool (R) until securely tightened. Vary depending on
suface thickness (Shown Above)
1E. Finally attach cable cap (G) to the
back of clamp. (Shown Above) -
Grommet Mount Installation:
2A. Insert long screw (H) into metal piece (I) then align to holes of base pole and turn in provided screws (N) with allen tool(R). (Shown Above)
2B. Align assembled grommet screw through hole on table then insert big washer(J) also washer (L) then tighten nut (K) securely. (Shown Above) -
Mounting Arm to Pole:
3A. Align Tool and cable organizer (Q) to the pole (C) and slide it down. Use allen tool (S) to secure it in desired place. (Shown Above) -
Tilt & Orientation Adjustability: 4A. Adjust to desired angle then tighten the screws using allen key (S) as shown, alternating from each screw as you tighten them.
-
Connecting VESA Mount to Security Enclosure:
5A. Align VESA plate from arm to VESA holes of security holder and turn in screws (U) until securely tightened. -
Cable Routing:
6A. Using the provided clips, route the wire from your device to the power source as illustrated to the right. -
Security: 7A. To secure device in place insert provided key (V) into holder keylock and turn it clockwise to lock it. (As shown)
Arm Adjustability
To
properly balance the arms with holder mounted, adjust the spring tension using
the supplied allen key (S) as follows:
First, position and firmly hold the arm horizontally as shown bellow. Ask for
assistance should you require it.
To avoid damage to enclosure or mount,
always keep the arms in horizontal position while making adjustments. Again,
ask for assistance if required.
If the arm drops, turn the adjustment screw counter-clockwise until it stays
in a horizontal position.
If the arm rises, turn the adjustment screw clockwise until it stays in a
horizontal position.
DO NOT over tighten the screws.
36 Taaffe Place Brooklyn, NY 11205
support@ctadigital.com
888-733-4448
www.ctadigital.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>