HUBBARDTON FORCE 51644 Alcove Post Light Instruction Manual
- June 13, 2024
- HUBBARDTON FORCE
Table of Contents
HUBBARDTON FORCE 51644 Alcove Post Light
ASSEMBLY &INSTALLATION INSTRUCTIONS
Component Parts
NOTE: Items A through F are options sold and shipped separately to allow for various site situations and shown here for reference during installation as applicable
- A Post / Pier Mount – Optional and sold separately
- B J Bolt (4) – Included with optional post/pier mount
- C Flat Washer (4) – Included with optional post/pier mount
- D Split Washer (4) – Included with optional post/pier mount
- E Hex Nut (4) – Included with optional post/pier mount
- F Cover Cap – Optional and sold separately
- G Set Screw
- H Fixture
- I Bulb (not included)
- J Socket
- K Glass
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
To Install
(See Figure 1, next page)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
NOTE: Fixture, Post and Cover Cap each sold separately.
SITE PREPARATION
-
Run appropriate wiring to the site of the fixture, leaving enough excess wire to reach the top of the post, plus 12 inches.
-
Pour flat and level concrete base with wiring emerging at the center. Insert J bolts (B) so approximately 1″ of the bolts are exposed above the concrete. Position J bolts according to the template on the last page of these instructions. Allow concrete to cure before installing fixture.
INST ALLATION:
NOTE: Post may be cut to desired height before installation. -
Position post (A) over J bolts (B), feeding supply wire up though the post and secure using flat washers (C), split washers (D) and hex nuts (E).
-
Place optional cover cap (sold separately) (F) over post (A) to conceal mounting hardware.
-
Connect fixture wires to supply wires using appropriate wire connectors (not provided), black to black (or smooth), white to white (or ribbed) and tinned copper or green to tinned copper or green.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY AND NO BARE WIRE IS EXPOSED. -
Place fixture (H) onto post (A), carefully tucking all wiring down into post and making sure no wires are pinched between the post and the fixture. Secure with set screw (G).
-
Carefully unpack glass (K).
-
Install bulb (not included) (I) into socket (J).
-
Slide glass (K) inside frame of fixture (H) and allow to rest fully on fixture (H).
-
Restore electricity at main breaker.
USE THIS TEMPLATE TO POSITION J BOLTS AND WIREWAY IN CONCRETE SLAB PRIOR TO INSTALLING OUTDOOR POST MOUNTED LIGHTING FIXTURE.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product. We hope you enjoy your fixture!
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>