MONDOLUX ME09SS Impact 3535 Surface Mounted Suspended LINEAR LED Instruction Manual
- June 13, 2024
- MONDOLUX
Table of Contents
MONDOLUX ME09SS Impact 3535 Surface Mounted Suspended LINEAR LED
Product Information
The Impact 3535 Surface Mounted/Suspended Linear LED is a lighting fixture designed for installation in various settings. It is available with the product code ME09SS and can be found on the website mondolux.com.au.
Product Usage Instructions
- Ensure that the mains power is turned off before starting the installation process.
- For Surface Mounted Installation:
- Mark the mounting points evenly based on the number of mounting clips, considering the length of the extrusion. Refer to Picture 3 for reference.
- Drill and screw the mounting clips directly to the ceiling.
- Click on the fitting into the mounting clips. See Picture 4 for guidance.
- Proceed to step 7.
- For Suspended Installation:
- Mark the suspension points evenly based on the number of suspension kits, considering the length of the extrusion.
- Drill and screw the base of the ceiling suspension end into the ceiling at the marked locations. Refer to Picture 5 for guidance.
- Thread the other part of the ceiling suspension into the base.
- Adjust the suspension height by maintaining even suspension across the length. See Picture 6 for reference.
- Turn on the mains power. The installation is now complete.
Installation
Notes
- This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by qualified electrician.
- Electrical Wiring and installation should always comply as per the local standards.
- Do not open or interchange any parts of this fitting or the warranty is void.
- The fitting may be hot to touch after continuous use.
- Do not install the fitting near heat source.
- Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting. Issues caused by such wirings are not covered under our warranty policy.
- If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.
Care & Refinishing
Mondolux strongly recommends following cleaning procedures to maintain proper finish of the product.
- Do not use bleach or concentrated solvents under any circumstances.
For a Black finish:
- Wipe gently with a soft damp cloth or chamois.
- Do not use any abrasive compounds.
DIMENSIONS
Installation Steps
- Ensure the mains power is turned off.
- For Surface Mounted Installation: Mark the mounting points evenly based on the number of mounting clips depending on the length of the extrusion. See Picture 3.
- Drill and screw the mounting clips directly to the ceiling and click-in the fitting into the mounting clips. See Picture 4. Goto step 7.
- For Suspended Installation: Mark the suspension points evenly based on the number of suspension kits depending on the length of the extrusion.
- Drill and screw the base of the ceiling suspension end into the ceiling in those locations. See Picture 5.
- Now, thread the other part of the ceiling suspension into the base. Adjust the suspension height by maintaining even suspension across the length. See Picture 6.
- Turn the mains on. Installation is complete.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>