injen TECHNOLOGY SES9300MD Stainless Steel Exhaust System Instruction Manual
- June 13, 2024
- Injen Technology
Table of Contents
SES9300MD Stainless
Steel Exhaust System
Instruction Manual
STAINLESS STEEL EXHAUST SYSTEM
Part Number: SES9300MD
Installation Instructions
| YEAR | MAKE | MODEL | ENGINE |
|---|---|---|---|
| 2021-2022 | FORD | BRONCO (2DR & 4DR) | L4-2.3L TURBO |
| 2021-2022 | FORD | BRONCO (2DR & 4DR) | V6-2.7L TWIN TURBO |
PARTS INCLUDED
| ITEM | QTY | PART NO. | DESCRIPTION |
|---|---|---|---|
| A | 1 | W-SES9300MD | Muffler delete pipe |
RECOMMENDED TOOLS
| Ratcheting Wrench | 10mm socket | 15 mm socket |
|---|
BEFORE YOU BEGIN
Please check the list of parts included and report any defective or missing
parts to the authorized Injen dealer you purchased this product from. Before
installing any parts of this system, please read the instructions thoroughly.
If you have any questions regarding installation, please contact your Injen
Technology dealer. Installation DOES require some mechanical skills. A
qualified mechanic is always recommended.
This product includes a Limited Lifetime Warranty to the original purchaser
against defects in material and workmanship on all Injen exhaust systems Any
and all warranty coverage is limited to the repair or replacement of the
defective part only, at Injen Technology’s discretion. The warranty does not
cover incidental or consequential damages, nor does it cover the cost of
installation or removal of the defective part or its replacement. Proof of
purchase is required.
Do not attempt to install the exhaust system while the engine is hot. Severe
burn could result from touching hot engine components.
WARNING : Failure to follow installation instructions and not using the
provided hardware may damage the exhaust system, engine, or components of
either.
Note : It is always recommended to disconnect your battery before
disconnecting any sensors.
- Remove the stock muffer by loosening the mid pipe clamp and detaching the muffer from the rubber insulators.
- Insert the hanger to the rubber insulator then connect the muffer delete pipe to the mid pipe.
- Secure the muffer delete pipe using the OEM clamp.
CONGRATULATIONS! You have just completed the installation of this exhaust system. Periodically, check the alignment of the exhaust, normal wear and tear can cause nuts and bolts to come loose. Note: Check clearance and adjust if needed! Failure to check the alignment and adjust the exhaust can cause damage that will void the warranty. Injen Technology is not responsible for any damages caused by/from improper installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>