injen TECHNOLOGY SES9300MP Stainless Steel Exhaust System Instruction Manual
- June 13, 2024
- Injen Technology
Table of Contents
TECHNOLOGY SES9300MP
Stainless Steel Exhaust System
Instruction Manual
STAINLESS STEEL EXHAUST SYSTEM
Part Number: SES9300MP
Installation Instructions
| YEAR | MAKE | MODEL | ENGINE |
|---|---|---|---|
| 2021-2022 | FORD | BRONCO (2DR & 4DR) | L4-2.3L TURBO |
| 2021-2022 | FORD | BRONCO (2DR & 4DR) | V6-2.7L TWIN TURBO |
PARTS INCLUDED
| ITEM | QTY | PART NO. | DESCRIPTION |
|---|---|---|---|
| A | 1 | W-SES9300-1 | Front pipe |
| B | 1 | W-SES9300-2 | Mid pipe extension (4 door models only) |
| C | 1 | W-SES9300-3 | Mid pipe |
| D | 1 | X-17202 | 66mm AS Band clamp SUS304 |
| E | 2 | X-4015 | 76mm SS Slip fit torsion clamp |
TOOLS REQUIRED
| Ratcheting Wrench | 10mm socket | 15mm socket |
|---|
BEFORE YOU BEGIN
Please check the list of parts included and report any defective or missing
parts to the authorized Injen dealer you purchased this product from. Before
installing any parts of this system, please read the instructions thoroughly.
If you have any questions regarding installation, please contact your Injen
Technology dealer. Installation DOES require some mechanical skills. A
qualified mechanic is always recommended.
This product includes a Limited Lifetime Warranty to the original purchaser
against defects in material and workmanship on all Injen exhaust systems Any
and all warranty coverage is limited to the repair or replacement of the
defective part only, at Injen Technology’s discretion. The warranty does not
cover incidental or consequential damages, nor does it cover the cost of
installation or removal of the defective part or its replacement. Proof of
purchase is required.
Do not attempt to install the exhaust system while the engine is hot. Severe
burn could result from touching hot engine components.
WARNING : Failure to follow installation instructions and not using the
provided hardware may damage the exhaust system, engine, or components of
either.
Note : It is always recommended to disconnect your battery before
disconnecting any sensors.
-
Remove the two nuts securing the mid pipe to the OEM fiex pipe. Then detach the front hanger from the rubber insulator.
-
Detach the midpipe hanger from the rubber insulator.
-
Remove the OEM mid pipe.
-
Connect the front pipe to the OEM fiex pipe, then insert the hanger to the rubber insulator. Secure using the OEM fasteners.
-
FOUR DOOR MODELS ONLY: Attach the mid pipe extension to the front pipe.
Secure using the provided 76mm clamps. -
Connect the mid pipe to the front pipe.
Secure using the provided 76mm clamps. -
Insert the mid pipe hanger to the rubber insulator.
-
Connect the mid pipe to the OEM muffer and secure using the provided 66mm clamp.
-
Ensure all bolts and clamps are properly secured.
CONGRATULATIONS! You have just completed the installation of this exhaust
system. Periodically, check the alignment of the exhaust, normal wear and tear
can cause nuts and bolts to come loose.
Note: Check clearance and adjust if needed! Failure to check the alignment and
adjust the exhaust can cause damage that will void the warranty. Injen
Technology is not responsible for any damages caused by/from improper
installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>