NICE 2GIG-ANT5XL-GC3 2GIG EDGE External Antenna Installation Guide
- June 13, 2024
- Nice
Table of Contents
2GIG-ANT5XL-GC3 2GIG EDGE External Antenna
Installation Guide
Antenna Model 2GIG-ANT5XL-GC3
To Connect the external antenna to the Edge Panel, you will need the gray jumper that is provided inside of the EDGE box.
- You will need to remove the battery connection and unplug the transformer to power down panel.
- Place the panel face down and remove the four screws located at the edges of the panel then carefully remove the back cover.
- Next you will have to remove the black jumper located on the bottom left side of the board on the left side of the red and black wire connector.
- Place the jumper that you disconnected into the jumper holder located above the red and black wire connector to avoid a short on the panel.
- Now you must snap in one of the connectors on the gray jumper into the location where the black jumper was just removed.
- Next, you will have to snap in the other side of the gray jumper into ANT2 located on the bottom center of the board.
- Feed your External Antenna through the opening on the center of the back plate and use the antenna clip located on the left side of the battery to run your wire down.
- Once the wire is fed through the wire holder you must push in the External Antenna connector to ANT1 located in the bottom center of the board next to ANT2.
- Finally, place the rear cover back on to panel re screw the four screws.
There is no programming in the settings for the External Antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>