NICE 2GIG EDGE Image3 Install Installation Guide

June 13, 2024
Nice

NICE 2GIG EDGE Image3 Install Installation Guide
Technical Bulletin Logo

Step 1: Installation

Verify installation of the XCVR3 is connected to the corresponding terminals

Step 2: Program Image Sensor

  • Added under Image Sensor in Panel Programming.
    Configuration

  • Specs

  • Sensor Type: Interior Follower- 04

  • Add in Image Sensor: Place in Console into “Add Mode”

  • Install Batteries into Image sensor, and should learn in and say “Image1”
    Configuration

  • Description: “Office” Chime- Disabled / Sensitivity: Normal / Smart Area 1 /

  • Transmission Delay- Enabled / Reports- Enabled / Supervision-Enabled

  • Save Changes by Exiting Programming

Step 3: View under ADC Image Sensors

Verify on the Alarm.com Dealer Site the customer account has an Image Sensor capable service plan and view on EDGE for settings under Image Sensors if needed.

Quick Tips if issues occur:

  • Verify EDGE is on latest Firmware 3.1.1.016
  • Power cycle panel if not able to View Image sensor on account after panel integration.

Technical Bulletin Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals