NICE 2GIG Image Sensor Setup Installation Guide
- June 13, 2024
- Nice
Table of Contents
**NICE 2GIG Image Sensor Setup Installation Guide
**
Technical Bulletin
2GIG Image Sensor – Setup
Basic install
Highlighted Features
- Battery operated
- Communicates wirelessly to the security control panel
- 35 feet by 40 feet detection coverage area
- Configurable PIR sensitivity and pet immunity settings
- Image: QVGA 320×240 pixels
- Color Images (except in night vision)
- Night vision image capture with infrared flash (black & white)
- Tamper detection, walk test mode, supervision
HARDWARE COMPATIBILITY & REQUIREMENTS
- Security Control Panel: 2GIG Go! Control with software 1.10 & up
- Communication Module: 2GIG Cell Radio Module
- Required Radio: 2GIG-XCVR2-345
- Available Zones: One zone per Image Sensor installed (Up to 3 Image Sensors per system)
HARDWARE INSTALLATION
Attempting to Rejoin Network| Slow Blink for 5 Seconds at a Time| Peycle until
the sensor reconnects to its network. (Note: This means the sensor has already
been enrolled into a network and is trying to connect to it. If attempting to
enroll sensor in a new network, hold reset button for a full 10 seconds (until
LED blinks rapidly) to clear the old network before adding to new network.)
---|---|---
Motion Test Mode| Solid for 3 Seconds at a Time| Repeats for each motion
activation during the 3 minutes after sensor joins network, has been tampered,
or is placed in PIR test mode. (Note: In test mode, there is an 8 second
“sleep” timeout between motion trips.)
Network Communication Problem| Fast Blink for 1 Second at a Time| Pattern
begins after 60 seconds of searching for (and unsuccessfully joining) a
network and repeats until RF communication is restored. Pattern persists as
long as the sensor is not enrolled in a network or cannot connect to current
network.
Speciation
If the camera LED is blinking, refer to this chart for LED trouble diagnostics.
Image Sensor Red Status LED Activity Reference
Device Status or Error| LED Pattern| Duration of LED Pattern
Sensor Power- Up| Solid for 5 Seconds| Approximately first 5 seconds after
powering.
Sensor Joins or Rejoins Network| Solid for 5 Seconds| First 5 seconds after
sensor joins a new network (during enroll process) or rejoins its existing
network.
Searching for Network to Join| Fast Blink for 5 Seconds at a Time| Repeats
pattern for up to 60 seconds after powering until the sensor enrolls in a
network
Basic Operation:
PRODUCT SUMMARY
The Image Sensor is a pet immune PIR (passive infrared) motion detector with a built-in camera. The sensor is designed to capture images during alarm or non- alarm events. Users can also initiate image capture on-demand to Peek-In on their property. Images are stored locally and uploaded either automatically when motion is captured during alarm events or manually when requested by the user. Once uploaded, images are available for viewing on the Alarm.com Website or an Alarm.com Smart phone app. The sensor is battery powered, all wireless and simple to install and operate. A system with a 2GIG Cell Radio Module connected to an Alarm.com account with service plan subscription is required. For additional information on product features, functionality and service plan options, visit the Alarm.com Dealer Site (www.alarm.com/dealer).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>