REDCAT 1953 COE Light Kit Instruction Manual
- June 13, 2024
- REDCAT
Table of Contents
1953 COE Light Kit
Instruction Manual
MAN-
COELIGHTKIT-23-8-29
Included Items
Control Unit Overview
CH1: Receiver Channel 1 & Steering Servo (not used).
CH2: Receiver Channel 2 & ESC RX lead (using Y-Adapter)
P1: Marker lights (3mm amber LEDs)
P2: Headlights (5mm white LEDs)
P3: Left steering signal (not used)
P4: Right steering signal (not used)
P5: Brake lights (3mm red LEDs)
P6: Not used
P7: Reverse lights (3mm white LEDs)
P8: Marker lights (3mm amber LEDs)
K2: Jumper cao
installed – Brake light is fully illuminated when braking. Brake light is 50%
illuminated in all other throttle trigger positions.
Jumoer cao removed – Brake light is fully illuminated only when the throttle
trigger is in the neutral position. Brake light is off in all other throttle
trigger positions.
K3: Jumoer cao installed – Steering signal is reversed
K4: timer can installe4 – Brake signal is reversed
Wiring Diagram
LED Placement
Installation
Remove the body and install the control unit to the chassis, next to the
receiver box.
Insert the long end of a Y-Adapter (B) into the CH2 slot of the control unit.
Be sure to line up the Black/Brown wire with the (-) symbol. See “Control Unit
Overview”. Plug the ESC’s receiver wire into the female plug of the Y-Adapter
(B). Plug the remaining plug on the Y-Adapter (B) into CH.2 of the vehicle’s
receiver. See “Wiring Diagram” section.
Plug wire harness NO.1 into Socket 1 of the control unit. This harness will be
fastened to the body. Using the LED clips and M2.5×4 screws, that were
included with your COE kit, fasten the two 5mm clear bulbs into the headlight
buckets and the two 3mm amber bulbs into the front marker light buckets. Refer
to “LED Placement” for bulb placement.
Plug wire harness NO.2 into Socket 2 of the control unit. This harness will be
fastened to the underside of the bed. Using the LED clips and M2x6 screws,
that were included with your COE kit, fasten the bulbs into the appropriate
light buckets. Refer to the “LED
Placement” section for bulb placement. The unused wire harness connector plug
will be used to power the optional trailer LED light kit.
Using the included wire ties and wire clips, fasten the wires neatly to the
chassis and/or body to keep the wires from harms way. Be sure to arrange wires
in a way that they won’t interfere the ramp storage compartment located at the
rear of the vehicle.
The optional Custom Trailer Light Kit (RER23174) plugs directly into the rear
of the COE Light Kit’s main wire harness.
Follow us
Follow us on social media
Take a photo, create a video, post and share your Redcat experience.
Please add these tags to your posts: #redcatnation, #redcatcreations,
scalefunforeveryone
Stay up to date on the latest Redcat news, products, and creative content. While these profiles are not customer service channels, you might find that one of our subject experts or another member of the community is able to assist you. If you have an issue or need technical and or product support, please reach out to Redcat directly through our website.
redcatracing.com
facebook.com/RedcatRacing
facebook.com/groups/redcatlowriders
instagram.com/redcatracing
youtube.com/user/RedcatRacing
twitter.com/RedcatRacing
pinterest.com/redcatracingaz
tiktok.com/@redcatracing