AUDIOPHONICS LPS-A6 Linear Power Supply Module Installation Guide
- June 13, 2024
- AUDIOPHONICS
Table of Contents
INSTALLATION GUIDE
INSTALLING THE LPS-A6 POWER SUPPLY
MODULE IN THE EVERSOLO DMP-A6 / DMP-A6
MASTER EDITION
Tools required
- LPS-A6 power supply kit
- EverSolo DMP-A6 / DMP-A6 Master Edition
- Phillips screwdriver
- Allen key 2.0mm
Step 1: Use a 2.0mm allen key to unscrew the 6 screws on the rear panel
and the 7 screws on the underside of the unit. Total screws to remove:
13.Step 2: Gently slide the device cover
outwards about 20mm. Two webs connect the screen to the motherboard. Don’t use
too much force.
Step 3: Lift and tilt the
cover (gently). Caution: cables are attached to the cover, screen and
motherboard. Do not undo them.Step 4: Identify the switch
mode power supply (SMPS) of the DMP-A6.
Step 5: Disconnect the jumper cable. This is a latched connector. Press the central part to unlock it, then pull it gently upwards.
Step 6: Use a Phillips screwdriver to remove the 6 screws securing the switching power supply.
Step 7: Remove the switching power supply module from the DMP-A6 and prepare the LPS-A6 module.
Step 8: Locate the insulation rings (4 pieces). Place them on the PCB spacers as shown in the following photos.
Step 9: Install the LPS-A6. Place it on the 4 isolation rings. Align the LPS-A6 correctly with the spacers. Note that the rings may move slightly. Use the 2.0mm allen key to align them.
Step 10: Use the existing screws to secure the LPS-A6 module to the chassis. Use a Phillips screwdriver to tighten the 4 screws. You’ll have a surplus of 2 screws. Keep them in a safe place.
Step 11: Install the silver-plated cable. Plug the connectors firmly into the sockets as shown in the following photos.
Step 12: Close and gently tilt the cover downwards. Remember that the cables are attached to the cover screen and to the motherboard. Do not disconnect them.
Step 13: Gently slide the cover inwards. Secure the cover to the rear and bottom panels. Use your 2.0mm allen key to tighten the 6 screws on the rear panel and the 7 screws on the underside of the unit.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>