PRO AQUA PRO-E-SF20 Whole House Salt-Free Water Softener Conditioner Installation Guide
- June 13, 2024
- PRO AQUA
Table of Contents
PRO AQUA PRO-E-SF20 Whole House Salt-Free Water Softener Conditioner
Installation Guide
Installations Instructions
-
Turn off feed water main before proceeding
-
Mount the ELITE System to the wall. Ensure the system is leveled.
-
Position the SF Tank approximately 8-10″ from the ELITE System “OUT” port.
-
Lubricate the O-rings on the bypass and Elbow Fittings. (Fig 3.)
-
Connect the Bypass to the SF Head. (Fig 3.) 6 Connect the Elbows to the Bypass. (Fig 3.)
-
Connect the 1″x1″ NPT adapter to the Elite System “OUT” port.
-
Connect a Flex hose (provided) from the “OUT” port of the ELITE System to the “UPFLOW INLET” elbow on the SF System.
-
Connect the incoming water line to the “IN” port on the ELITE System. (Fig 1.)
-
Connect the “OUT/DOWNFLOW INLET” port on the SF System to the pipe going into your home. (Fig 1.)
-
Ensure the Bypass is in “Service Position.” (Fig 2.)
-
Slowly turn on your main feed water line.
-
Check for leaks. If any, turn off the main water and address the issue. Contact a licensed plumber if needed.
-
Locate the nearest faucet to the system, remove the screen, and open the cold water for 10-15 min.
-
Done – Your system is now ready for use.
- “Installing a system shutoff valve and bypass is recommended for servicing
- Installing a ground jumper cable is also recommended to comply with your local electrical laws.
- Install this system according to your local laws. It is highly recommended to have this unit installed by a licensed professional.
- Outdoor and improper installation or usage voids the warranty.
SF Series Installation
www.proaquawater.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>