MONDOLUX ME02SM Stealth 0809 Surface Mounted Linear LED Light Installation Guide

MONDOLUX ME02SM Stealth 0809 Surface Mounted Linear LED Light

Product Information

• Product Name: Stealth 0809 Surface Mounted LINEAR LED
• Product Code: ME02SM
• Website:mondolux.com.au
• Power Input: 220-240V AC/50Hz
• Care & Refinishing: The fitting may be hot to the touch after continuous use. Do not install the fitting near a heat source.
• Do not install any inductive loads such as exhaust fans or pond pumps within the same lighting circuit.
• If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.

Product Usage Instructions

1. Ensure the mains power is turned off.
2. Trim the extrusion based on the required size. See Picture 1.
3. Assemble the extrusion with a suitable LED strip by sticking it to the extrusion base. Install the diffuser and end caps. See Picture 2.
4. If you have a fully assembled kit, ignore Step 2 and Step 3.
5. Screw the mounting clips in the desired location using the provided screws. See Picture 3.
6. Click the extrusion into the mounting clips in position and connect it to the DC24V side of the driver provided separately. It is recommended to use 2 clips per meter for a secure installation. See Picture 4.
7. Installation is complete. Turn the mains on. See Picture 5.

Note: Electrical wiring and installation should always comply with local standards. Do not open or interchange any parts of this fitting as it will void the warranty.

Notes

• This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by qualified electrician.
• Electrical Wiring and installation should always comply as per the local standards.
• Do not open or interchange any parts of this fitting or the warranty is void.
• The fitting may be hot to touch after continuous use.
• Do not install the fitting near heat source.
• Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting.
• Issues caused by such wirings are not covered under our warranty policy.
• If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.

Care & Refinishing

• Mondolux strongly recommends following cleaning procedures to maintain proper finish of the product.
• Do not use bleach or concentrated solvents under any circumstances.
• For Black finish: Wipe gently with a soft damp cloth or chamois. Do not use any abrasive compounds.

Dimension

Installation Steps

1. Ensure the mains power is turned off.
2. Trim the extrusion based on the required size. See picture 1.
3. Assemble the extrusion with suitable LED strip by sticking to the extrusion base. Install the diffuser and end caps. See Picture 2.
4. Ignore Step 2 and Step 3 for fully assembled kit.
5. Screw the mounting clips in desired location using the provided screws. See picture 3.
6. Click the extrusion into the mounting clips in position and connect to the DC24V side of the driver provided separately. It is recommended to use 2 clips per meter for a secure installation. See picture 4.
7. Installation is complete. Turn the mains on. See picture 5.

mondolux.com.au

Documents / Resources

| MONDOLUX ME02SM Stealth 0809 Surface Mounted Linear LED Light [pdf] Installation Guide
ME02SM, ME02SM Stealth 0809 Surface Mounted Linear LED Light, Stealth 0809 Surface Mounted Linear LED Light, Surface Mounted Linear LED Light, Linear LED Light, LED Light
---|---

References

• Mondolux | Innovative Commercial Lighting Supplier Australia

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>