MONDOLUX ME09RE Impact 3535 Recessed LINEAR LED Installation Guide
- June 13, 2024
- MONDOLUX
Table of Contents
MONDOLUX ME09RE Impact 3535 Recessed LINEAR LED
Product Information: Impact 3535 Recessed Linear LED
- Product Code: ME09RE
- Website: mondolux.com.au
Installation Manual
Notes:
- The Impact 3535 Recessed Linear LED is designed for installation in ceilings.
- Please ensure the mains power is turned off before installation.
- Refer to the provided pictures for visual guidance.
Care & Refinishing
To maintain the appearance and functionality of the Impact 3535 Recessed
Linear LED, follow these care instructions:
- Regularly clean the fixture using a soft cloth or brush.
- Avoid using abrasive cleaners or solvents that may damage the surface.
- In case of any damage or malfunction, contact the manufacturer for professional assistance.
Installation Steps
- Ensure the mains power is turned off.
- Impact 3535 Recessed Extrusion comes with the required number of spring clips based on the requested length. At one point, only 1 spring clip is required to hold the extrusion in position. Refer to Picture 1.
- Adjust the spacing of the spring clips mounted on the base of the extrusion by sliding them back and forth to achieve the best grip. Slide the remote driver and then the extrusion into the ceiling. Refer to Picture 2.
- Turn on the mains. The installation is now complete. See Picture 3.
Picture 1
(Insert Picture 1 here)
Picture 2
(Insert Picture 2 here)
Picture 3
(Insert Picture 3 here)
Installation Manual
Notes
- This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by qualified electrician.
- Electrical Wiring and installation should always comply as per the local standards.
- Do not open or interchange any parts of this fitting or the warranty is void.
- The fitting may be hot to touch after continuous use.
- Do not install the fitting near heat source.
- Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting. Issues caused by such wirings are not covered under our warranty policy.
- If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.
Care & Refinishing
Mondolux strongly recommends following cleaning procedures to maintain proper finish of the product.
- Do not use bleach or concentrated solvents under any circumstances.
- For Black finish: Wipe gently with a soft damp cloth or chamois. Do not use any abrasive compounds.
Installation Steps
- Ensure the mains power is turned off.
- Impact 3535 Recessed Extrusion comes with required number of spring clips based on the length requested. At one point, only 1 spring clip is required to hold the extrusion in position. See Picture 1.
- Adjust the spacing of the spring clips mounted on the base of extrusion by sliding them back and forth, to get the best grip. Slide the remote driver and then the extrusion into ceiling. See Picture 2.
- Turn on the mains. Installation is complete. See picture 3.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>