MONDOLUX ME10SS Impact 5032 Surface Mounted Suspended Linear LED Instruction Manual

MONDOLUX ME10SS Impact 5032 Surface Mounted Suspended Linear LED

Product Information

The Impact 5032 Surface Mounted/ Suspended Linear LED is a lighting fixture designed for installation on ceilings. It is ideal for both surface mounted and suspended applications. The product code for this model is ME10SS. For more information, please visit mondolux.com.au.

Product Usage Instructions

1. Ensure the mains power is turned off.

2. Surface Mounted Installation:

   • Mark the mounting points evenly based on the number of mounting clips depending on the length of the extrusion. Refer to Picture 3.
   • Drill and screw the mounting clips directly to the ceiling.
   • Click-in the fitting into the mounting clips. Refer to Picture 4.

3. Suspended Installation:

   • Mark the suspension points evenly based on the number of suspension kits depending on the length of the extrusion.
   • Drill and screw the base of the ceiling suspension end into the ceiling in those locations. Refer to Picture 5.
   • Thread the other part of the ceiling suspension into the base.
   • Adjust the suspension height by maintaining even suspension across the length. Refer to Picture 6.

4. Turn the mains power on. The installation is complete.
   Note: Please refer to Picture 1, Picture 2, Picture 3, Picture

5. Picture 5, and Picture 6 in the installation manual for visual guidance.

Product code ME10SS

Installation

Notes

• This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by a qualified electrician.
• Electrical Wiring and installation should always comply as per local standards.
• Do not open or interchange any parts of this fitting or the warranty is void.
• The fitting may be hot to the touch after continuous use.
• Do not install the fitting near heat source.
• Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting. Issues caused by such wirings are not covered under our warranty policy.
• If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.

Care & Refinishing

Mondolux strongly recommends following cleaning procedures to maintain the proper finish of the product.

• Do not use bleach or concentrated solvents under any circumstances.
• For Black finish: Wipe gently with a soft damp cloth or chamois. Do not use any abrasive compounds.

Installation Steps

1. Ensure the mains power is turned off.
2. For Surface Mounted Installation: Mark the mounting points evenly based on the number of mounting clips depending on the length of the extrusion. See Picture 3.
3. Drill and screw the mounting clips directly to the ceiling and click-in the fitting into the mounting clips. See Picture 4. Goto step 7.
4. For Suspended Installation: Mark the suspension points evenly based on the number of suspension kits depending on the length of the extrusion.
5. Drill and screw the base of the ceiling suspension end into the ceiling in those locations. See Picture 5.
6. Now, thread the other part of the ceiling suspension into the base. Adjust the suspension height by maintaining even suspension across the length. See Picture 6.
7. Turn the mains on. Installation is complete.

mondolux.com.au

References

• Mondolux | Innovative Commercial Lighting Supplier Australia

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>