MONDOLUX ME11SS Impact 7532 Surface Mounted Suspended Linear LED Instruction Manual

June 13, 2024
MONDOLUX

MONDOLUX ME11SS Impact 7532 Surface Mounted Suspended Linear LED

Product Information

  • Product Name: ISmupsapcetn7d5e3d2 Surface Mounted/ LINEAR LED
  • Product Code: ME11SS
  • Manufacturer: mondolux.com.au

Product Usage Instructions

  1. Ensure the mains power is turned off.
  2. For Surface Mounted Installation:
    • Mark the mounting points evenly based on the number of mounting clips depending on the length of the extrusion. See Picture 3.
    • Drill and screw the mounting clips directly to the ceiling and click in the fitting into the mounting clips. See Picture 4.
  3. For Suspended Installation:
    • Mark the suspension points evenly based on the number of suspension kits depending on the length of the extrusion.
    • Drill and screw the base of the ceiling suspension end into the ceiling in those locations. See Picture 5.
    • Thread the other part of the ceiling suspension into the base. Adjust the suspension height by maintaining even suspension across the length. See Picture 6.
  4. Turn the mains on. Installation is complete.

Notes

  • This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by a qualified electrician.
  • Electrical Wiring and installation should always comply with local standards.
  • Do not open or interchange any parts of this fitting or the warranty is void.
  • The fitting may be hot to the touch after continuous use.
  • Do not install the fitting near the heat source.
  • Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting. Issues caused by such wirings are not covered under our warranty policy.
  • If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931

Care & Refinishing

Mondolux strongly recommends following cleaning procedures to maintain the proper finish of the product.

  • Do not use bleach or concentrated solvents under any circumstances.
  • For a Black finish: Wipe gently with a soft damp cloth or chamois. Do not use any abrasive compounds.

Installation Steps

  1. Ensure the mains power is turned off.
  2. For Surface Mounted Installation: Mark the mounting points evenly based on the number of mounting clips depending on the length of the extrusion. See Picture 3.
  3. Drill and screw the mounting clips directly to the ceiling and click-in the fitting into the mounting clips. See Picture 4. Goto step 7.
  4. For Suspended Installation: Mark the suspension points evenly based on the number of suspension kits depending on the length of the extrusion.
  5. Drill and screw the base of the ceiling suspension end into the ceiling in those locations. See Picture 5.
  6. Now, thread the other part of the ceiling suspension into the base. Adjust the suspension height by maintaining even suspension across the length. See Picture 6.
  7. Turn the mains on. Installation is complete

Product code ME11SS mondolux.com.au

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals