HONDA CR-V No-Drill MudFlaps WeatherTech Instructions
- June 13, 2024
- Honda
Table of Contents
HONDA CR-V No-Drill MudFlaps WeatherTech
Product Information
The No-Drill MudFlaps are a set of mudguards designed to protect your vehicle from dirt, debris, and stains. They are easy to install and do not require any drilling. The mudflaps are compatible with vehicles that have standard-sized wheels and tires.
Product Usage Instructions
- Thoroughly wash your vehicle, removing all dirt, debris, and stains from each fender in the areas where the MudFlaps will be installed.
- Park the vehicle on level ground with the wheels turned fully to the left. Start with the driver’s side MudFlap installation.
- Locate the three factory Phillips head screws at the inner fender as indicated.
- Using the provided Phillips bit, ratchet, and appropriate socket, remove the three factory Phillips head screws at the inner fender. These screws will be reused.
- Using the MudFlap marked LH (left-hand), place it up to the fender and align it with the corresponding holes.
- Using the provided Phillips bit, ratchet, and appropriate socket, re-install the three previously removed factory Phillips head screws through the holes in the MudFlap. Then, tighten them to a snug fit.
- While firmly pressing the MudFlap up to the fender, fully tighten the three factory Phillips head screws.
- Install the passenger side MudFlap marked RH (right-hand) with the wheels turned fully to the right, repeating Steps 3-7.
- WARNING: The MudFlap is designed to fit vehicles with standard-sized wheels and tires. Installation of MudFlaps on vehicles with aftermarket wheels or oversized tires may interfere with the MudFlap, void the warranty, and cause damage to the MudFlap or the vehicle.
If you have any further questions or concerns, please contact us at 630-769-1500 or visit our website at weathertech.com/warranty.
What you Need
Installation Instructions
-
Thoroughly wash your vehicle, removing all dirt, debris and stains from each fender in the areas where the MudFlaps will be installed.
-
Park the vehicle on level ground with the wheels turned fully to the left. Begin with the driver’s side MudFlap installation.
-
Locate the (3) three factory Phillips head screws at the inner fender as indicated.
-
Using the provided Phillips bit, ratchet and appropriate socket, remove the (3) three factory Phillips head screws at the inner fender. They will be reused.
-
Using the MudFlap marked “LH,” place it up to the fender and align with the corresponding holes.
-
Using the provided Phillips bit, ratchet and appropriate socket, re-install the (3) three previously removed factory Phillips head screws through the holes in the MudFlap. Then, tighten to a snug fit.
-
While firmly pressing the MudFlap up to the fender, fully tighten the (3) three factory Phillips head screws.
-
Install the passenger side MudFlap marked “RH” with the wheels turned fully to the right, repeating Steps 3-7.
Congratulations!
Your new WeatherTech® No-Drill MudFlaps have been installed! Your WeatherTech®
No-Drill MudFlap carries a Lifetime Limited Warranty against defects in
materials and workmanship when installed correctly.
WARNING:
The MudFlap is designed to fit vehicles with standard-sized wheels and tires.
Installation of MudFlaps on vehicles with aftermarket wheels or oversized
tires may interfere with the MudFlap, will void the warranty and may damage
the MudFlap or the vehicle.
630-769-1500 weathertech.com/warranty
67MF750
© 2023 MacNeil IP LLC V1
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>