YEELIGHT YLYD08YI Wireless Charging Nightlight Owner’s Manual
- June 13, 2024
- Yeelight
Table of Contents
YEELIGHT YLYD08YI Wireless Charging Nightlight Owner’s Manual
Product Features
Power indicator (green)
Mobile charging Wireless charging center indicator (blue)
Nightlight — ON/OFF
Nightlight charging indicator
Instruction
-
Connect USB cable When green power indication s on, the product is standby.
-
Wireless charging Put mobile phone in wireless charging center. When Bluefin dictator is on, the phone s in charge. Adjust its position if the phone is noting charge.
NOTES:- Please confirm the mobile phone has wireless charging function.
- When blue indicator s flashing, wireless charging is out of connection or the phone is in overvoltage. protection. Please change the power adaptor or relocate the phone.
-
Nightlight charging Put nightlight in the charging position. The light s in charge when red indicator is on. While, when the ight spinful charge, the red indication is off automatically.
Basic Parameters
Model No. YLYDOBY! Input: 5V -12Va=2A
Output: 15W MAX
Transition: dmm Color temperature: 2700K/5000K
USB cable length: 1meter
USB cable load current: 2A MIN
EU Declaration of Conformity Hereby, Qingdao Eelier Information Technology Co, Ltd. declares that this Eyesight Wireless Charging Nightlight icing compliance with the essential requirements and other relevant provisions of Radio Equipment Directive 201/53/EU,
WEEE Disposal and Recycling Correct Disposal of this product. This marking indicates that this product should not be disposal with cither household wastes throughout the EUL To prevent possible harm to the environment E or human health from uncontrolled waste disposal recycled it responsibly to promote the sustainable reuse of material resources To return your used device, please use the return and collection systems or contact the retailer where the product was purchased They can take this product for environmental safe recycling.
Warning
- Do not put the nightlight near to any heat source, under sunlight, or in magnetic environment.
- Do not put nightlight in wireless charging arraign case nightlight loses of magnetism
- Cleaning the product with corrosive solvent is not allowed
- Keep the product away from kids younger than 3 years old
- Keep the product away from fire and water.
- Keep implantable medical devices (.e. heart pacemaker, implanted cochlear, etc.) at least 20cm away from the product in case of any interference.
- Do not put magnetic cards (ie. debit and credit cards) close to the product.
- 8 Please charge the nightlight in time when the light is dimmed or out of light.
- For indoor use only.
- Check the power source before using the product.
- For nervures replaceable light sources, the light source contained this luminaire shall only be replaced by the manufacturer or his service agent ora similar qualified electrician.
- This appliance contains batteries that are only replaceable by qualified electricians
- The luminaires shall be charged by an approved SELV power supply, and with constant output voltage equal orated voltage of this product.
The device has been evaluated to meet general RF exposure requirement. To maintain compliance with CE RF exposure ‘guidelines, this equipment should be installed and operated with minimum distance of 20cm between the radiator and your body.
A warning that batteries (battery pack or batteries installed) shal not be exposed to excessive heat such as sunshine, fire or the like. Caution risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. Charge at constant current of 0.2C until voltage reaches 425V, then charge at constant voltage 425V till charge current reduces to 0.02C.
ransmitted Power: -0.15 dBuA/m @10cm distance
Operating frequency (110-1485 KHz) can be usedin Europe without restriction
Approval Directive: Compliance with the essertial requirements and other relevant provisions of RED 2014/53 EU;
EN 62371: 2008; c E
EN 6059812015+A1. 2018
AL20TE; EN 60598-24:
Draft ETSI EN 301 483-1V2.2.0:2017;
Final draft ETSI EN 301 489-3V2.1.1:2017:
ETSIEN 303417 V11.12017;
FCC Compliance Statement:
This device complies with Part 18 of the FCC Rules. This device can generate
radio frequency energy, which could cause interferences to such products as
ratio, TV, baby monitor, cordless phone, Bluetooth, wireless router, etc.,
which can be confirmed by turning this product off
and on. If present, the user is encouraged to try to correct by taking one or
more of the following countermeasures:
-
Increase the spacing distance between the device and other product receding the interference.
-
If possible, use a properly instaled receiver antenna and/or reorient the receiving antenna of the other
product receiving the interference. -
Plugthe device into a different outlet from the
other product receiving the interference.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>