MONDOLUX ME04SM Stealth 1707 Surface Mounted Linear LED Instruction Manual
- June 13, 2024
- MONDOLUX
Table of Contents
MONDOLUX ME04SM Stealth 1707 Surface Mounted Linear LED
Product Information
The Stealth 1707 Surface Mounted Linear LED is a lighting fixture designed for surface mounting. It is suitable for indoor use and requires a power input of 220-240V AC/50Hz. The product code for this fixture is ME04SM. For more information, visit mondolux.com.au. Installation of this fitting should be done by a qualified electrician. It is important to comply with local electrical wiring and installation standards. Opening or interchanging any parts of the fitting will void the warranty. The fitting may become hot to touch after continuous use, so it should not be installed near a heat source. Additionally, avoid installing any inductive loads within the same lighting circuit as this can cause issues not covered under the warranty. If you have any installation questions, please contact Mondolux at 1300 601 931. Care and refinishing instructions are not provided in the text-extract.
Product Usage Instructions
- Ensure the mains power is turned off.
- Trim the extrusion based on the required size. Refer to Picture 1 for guidance.
- Assemble the extrusion with a suitable LED strip by sticking it to the extrusion base. Install the diffuser and end caps. See Picture 2 for reference.
- If you have a fully assembled kit, you can ignore Step 2 and Step 3.
- Screw the mounting clips in the desired location using the provided screws. Picture 3 illustrates this step.
- Click the extrusion into the mounting clips in the desired position and connect it to the DC24V side of the separately provided driver. It is recommended to use 2 clips per meter for a secure installation. Picture 4 provides visual guidance.
- Once the installation is complete, turn the mains power on. Refer to Picture 5 for reference.
Instruction
Notes
- This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by qualified electrician.
- Electrical Wiring and installation should always comply as per the local standards.
- Do not open or interchange any parts of this fitting or the warranty is void.
- The fitting may be hot to touch after continuous use.
- Do not install the fitting near heat source.
- Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting. Issues caused by such wirings are not covered under our warranty policy.
- If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.
Care & Refinishing
Mondolux strongly recommends following cleaning procedures to maintain proper finish of the product.
- Do not use bleach or concentrated solvents under any circumstances.
- For Black finish: Wipe gently with a soft damp cloth or chamois. Do not use any abrasive compounds.
Installation Steps
- Ensure the mains power is turned off.
- Trim the extrusion based on the required size. See picture 1.
- Assemble the extrusion with suitable LED strip by sticking to the extrusion base. Install the diffuser and end caps. See Picture 2.
- Ignore Step 2 and Step 3 for fully assembled kit.
- Screw the mounting clips in desired location using the provided screws. See picture 3.
- Click the extrusion into the mounting clips in position and connect to the DC24V side of the driver provided separately. It is recommended to use 2 clips per meter for a secure installation. See picture 4.
- Installation is complete. Turn the mains on. See picture 5.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>