Mondolux ME20SM Stealth 1616 Corner Mounted Linear LED Instruction Manual
- June 13, 2024
- MONDOLUX
Table of Contents
Mondolux ME20SM Stealth 1616 Corner Mounted Linear LED
Product Information
- Product Name : Stealth 1616 Corner Mounted LINEAR LED
- Product Code : ME20SM
- Manufacturer : Mondolux
- Website : mondolux.com.au
Product Usage Instructions
- Ensure the mains power is turned off.
- Trim the extrusion based on the required size. Refer to Picture 1 for guidance.
- Assemble the extrusion with a suitable LED strip by sticking it to the extrusion base. Install the diffuser and end caps. Refer to Picture 2 for guidance.
- If you have a fully assembled kit, you can ignore Step 2 and Step 3.
- Screw the mounting clips in the desired location using the provided screws. Refer to Picture 3 for guidance.
- Click the extrusion into the mounting clips in position and connect it to the DC24V side of the driver provided separately. It is recommended to use 2 clips per meter for a secure installation. Refer to Picture 4 for guidance.
- Once the installation is complete, turn the mains power on. Refer to Picture 5 for guidance.
Installation
Notes
- This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by a qualified electrician.
- Electrical Wiring and installation should always comply with local standards.
- Do not open or interchange any parts of this fitting or the warranty is void.
- The fitting may be hot to the touch after continuous use.
- Do not install the fitting near the heat source.
- Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting. Issues caused by such wirings are not covered under our warranty policy.
- If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.
Care & Refinishing
Mondolux strongly recommends following cleaning procedures to maintain the proper finish of the product.
- Do not use bleach or concentrated solvents under any circumstances.
- For Black finish: Wipe gently with a soft damp cloth or chamois. Do not use any abrasive compounds.
DIMENSIONS
Installation Steps
- Ensure the mains power is turned off.
- Trim the extrusion based on the required size. See picture 1.
- Assemble the extrusion with a suitable LED strip by sticking to the extrusion base. Install the diffuser and end caps. See Picture 2.
- Ignore Step 2 and Step 3 for the fully assembled kit.
- Screw the mounting clips in the desired location using the provided screws. See picture 3.
- Click the extrusion into the mounting clips in position and connect to the DC24V side of the driver provided separately. It is recommended to use 2 clips per meter for a secure installation. See picture 4.
- Installation is complete. Turn the mains on. See picture 5.
INSTRUCTIONS
Product code: ME20SM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>