SEALEY LED360.V5 Rechargeable 360° Inspection Light Instruction Manual

SEALEY LED360.V5 Rechargeable 360° Inspection Light

Product Information

Model No: LED360.V5, LED360G.V5, LED360R.V5

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY.
NOTE
THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Safety Instructions

1. Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or damaged DO NOT use.
2. Ensure the light is fully charged before initial use.
3. DO NOT charge in damp conditions.
4. DO NOT turn the light on when it is being charged.
5. DO NOT shine directly into your, another person’s or an animal’s eyes.
6. DO NOT allow children to use the light.
7. DO NOT handle or move the light whilst it is being charged.
8. DO NOT use the light if you suspect that the battery or the light casing is damaged.
9. DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use.
10. DO NOT attempt to open, disassemble, modify or service the battery pack.
11. DO NOT crush, puncture, short external contacts or dispose of in fire or water.
12. Replace only with the battery pack designated for this product.
13. Recycle or dispose of used battery as stipulated by local regulation.
14. If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.

Product Specifications

Model No| Battery| Charging Time| IP Rating| LED Type| Lumen Output Side(High/Low)Top| Maximum Length| Minimum Length| Operating Time Side(High/Low)/Top| Plug Type| Case Colour
---|---|---|---|---|---|---|---|---|---|---
LED360.V5| 3.7V 2.6Ah Li-ion| 3.5hr| IP54| 8W + 3W SMD (600/200)/120lm| 280mm| 260mm| (3/6)/8hr| 3-Pin BS| Black
LED360G.V5| 3.7V 2.6Ah Li-ion| 3.5hr| IP54| 8W + 3W SMD (600/200)/120lm| 280mm| 260mm| (3/6)/8hr| 3-Pin BS| Green
LED360R.V5| 3.7V 2.6Ah Li-ion| 3.5hr| IP54| 8W + 3W SMD (600/200)/120lm| 280mm| 260mm| (3/6)/8hr| 3-Pin BS| Red

Operation
Connect the USB lead to the socket on the rear of the light and into a charging socket. Turn on power supply, the charging LED on the light will light RED to show that charging has
commenced. Rotate to shine in any direction.

Battery Removal
Remove the 6 screws on the back of the lamp. Remove the back casing and disconnect the wiring from the circuit board. Remove the battery. Dispose of according to local government guidelines. Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.

360° 8W & 3W SMD LED RECHARGEABLE INSPECTION LIGHT

MODEL NO: LED360.V5, LED360G.V5, LED360R.V5

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Refer to instructions

SAFETY

• Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or damaged DO NOT use.
• Ensure the light is fully charged before initial use.
• DO NOT charge in damp conditions.
• DO NOT turn the light on when it is being charged.
• DO NOT shine directly into your, another person’s or an animal’s eyes.
• DO NOT allow children to use the light.
• DO NOT handle or move the light whilst it is being charged.
• DO NOT use the light if you suspect that the battery or the light casing is damaged.
• DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use.
• DO NOT attempt to open, disassemble, modify or service the battery pack.
• DO NOT crush, puncture, short external contacts or dispose of in fire or water.
• DO NOT expose to temperatures above 60°C (140°).
• Replace only with the battery pack designated for this product.
• Recycle or dispose of used battery as stipulated by local regulation.
• If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.

INTRODUCTION

Unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. Exclusive patented design owned and registered to Sealey. 8W SMD LED providing up to 600 lumens output with 120° spread of light, illuminating the whole work area. Includes an additional high power 3W LED directional torch. Features two swivel hooks and three rubber covered magnets, two on the rear and one on the end, which allow hands-free operation. High quality 2.6Ah lithium-ion battery for longer life, no memory effect and a much slower discharge than traditional Ni-MH batteries. Features a micro USB charging port and is supplied with charging cable.

SPECIFICATION

(600/200)/120lm
Maximum Length:| 280mm| 280mm| 280mm
Minimum Length:| 260mm| 260mm| 260mm
Operating Time Side(High/Low)/Top| (3/6)/8hr| (3/6)/8hr| (3/6)/8hr
Plug Type:| 3-Pin BS| 3-Pin BS| 3-Pin BS
Case Colour:| Black| Green| Red

• The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
• We will provide warranty against mechanical and electrical defect for a period of one year – this does not cover fair wear and tear. If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not replace the battery regardless of whether it is less than one year old.

Note: The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without another charge.

OPERATION

1. Connect the USB lead to the socket on the rear of the light and into a charging socket. Turn on power supply, the charging LED on the light will light RED to show that charging has commenced.
2. When the battery has fully charged the LED will turn GREEN.
3. Direct the lens away from your eyes before switching on.
4. Toggle the light between the end light and side light using the ON/OFF switch.
5. The light may be suspended by the hooks or attached to any ferrous surface by using the magnets.
6. When the light is hanging from the hook it can be rotated through 360° for more precise positioning.
7. Separate the top and bottom sections by pulling apart. When attached to a ferrous surface, using the base magnet, the light can rotate to shine in any direction.

BATTERY REMOVAL

• Remove the 6 screws on the back of the lamp. Remove the back casing and disconnect the wiring from the circuit board.
• Remove the battery. Dispose of according to local government guidelines.
• Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.

ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

• NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
• IMPORTANT: No Liability is accepted for incorrect use of this product.

WARRANTY

Guarantee is 12 months from purchase date, proof of which is required for any claim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500     [email protected] www.sealey.co.uk

© Jack Sealey Limited
LED360.V5, LED360G.V5, LED360R.V5 Issue 3 (H,3,) 29/09/23

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>