SEALEY LED3602.V3 SMD LED Rechargeable Inspection Lights Instruction Manual
- June 13, 2024
- SEALEY
Table of Contents
SEALEY LED3602.V3 SMD LED Rechargeable Inspection Lights
Thank you for purchasing a Sealey product. The model numbers available for this product are LED3602.V3, LED3602R.V3, LED3602G.V3, LED3602B.V3, LED3602Y.V3, and LED3602CF.V3. This product is manufactured to a high standard and, if used according to the provided instructions and properly maintained, it will give you years of trouble-free performance. Please read the following instructions carefully and take note of the safe operational requirements, warnings, and cautions. It is important to use the product correctly and with care for its intended purpose. Failure to do so may cause damage and/or personal injury and will invalidate the warranty. Keep these instructions safe for future use
Safety Precautions:
- Inspect the cable and connector for wear and damage before connecting to the power supply. If they are worn or damaged, do not use.
- Ensure the light is fully charged before initial use.
- Do not charge in damp conditions.
- Do not turn on the light while it is being charged.
- Do not shine the light directly into your, another person’s, or an animal’s eyes.
- Do not allow children to use the light.
- Do not handle or move the light while it is being charged.
- Do not use the light if you suspect that the battery or the light casing is damaged.
- Do not leave the battery in a discharged state. Recharge the battery immediately. Before storage, fully recharge the battery. Subsequently, recharge the battery at least once every six months of non-use.
- Do not attempt to open, disassemble, modify, or service the battery pack.
- Do not crush, puncture, short external contacts, or dispose of the battery in fire or water.
- Replace only with the designated battery pack for this product.
- Recycle or dispose of used batteries as stipulated by local regulations.
- If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.
Product Specifications:
- Model No: LED3602.V3
- Battery: 3.7V 2.2Ah Li-Ion
- Charging Time: 3.5 hours
- IP Rating: IP54
- LED Type: 4W + 3W SMD
- Lumen Output Side(High/Low)/Top: (400/200)/120lm
- Maximum Length: 270mm
- Minimum Length: 255mm
- Operating Time Side(High/Low)/Top: (3/7)8 hours
- Case Colour: Red, Black, Green, Blue, Yellow, Carbon Fibre
Product Usage Instructions
-
Connect the USB lead to the socket on the rear of the light.
-
Plug the USB lead into a USB power supply and turn it on. The charging LED on the light will light RED
to indicate that charging has commenced. -
When the battery has fully charged, the LED will turn GREEN.
-
Before switching on the light, direct the lens away from your eyes.
-
Toggle the light between the end light and side light using the ON/OFF switch. 6.
The light may be suspended by the hooks or… [instruction incomplete] Please
refer to the complete user manual for further instructions and information.
Thank you for purchasing a Sealey product. Manufactured to a high standard,
this product will, if used according to these instructions, and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE
OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND
WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE
INSTRUCTIONS SAFE FOR FUTURE USE.
SAFETY
- Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or damaged DO NOT use.
- Ensure the light is fully charged before initial use.
- DO NOT charge in damp conditions.
- DO NOT turn the light on when it is being charged.
- DO NOT shine directly into your, another person’s or an animal’s eyes.
- DO NOT allow children to use the light.
- DO NOT handle or move the light whilst it is being charged.
- DO NOT use the light if you suspect that the battery or the light casing is damaged.
- DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use.
- DO NOT attempt to open, disassemble, modify or service the battery pack.
- DO NOT crush, puncture, short external contacts or dispose of in fire or water.
- DO NOT expose to temperatures above 60°C (140°).
- Replace only with the battery pack designated for this product.
- Recycle or dispose of used battery as stipulated by local regulation.
- If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.
INTRODUCTION
Unique and innovative 360° swivel and tilt function enables the light source
to be positioned in any direction. Exclusive patented design owned by and
registered to Sealey. 4W SMD LED with magnified lens providing up to 400
lumens output with 120° spread of light, illuminating the whole work area.
Includes an additional high power 3W LED directional torch. Features two
swivel hooks and three rubber covered magnets, two on the rear and one on the
end, which allow hands-free operation. High quality 2.2Ah lithium-ion battery
for longer life, no memory effect and a much slower discharge than traditional
Ni-MH batteries. Micro USB charging port. Supplied with USB cable. (Mains
charger not included).
SPECIFICATION
Model No:| LED3602.V3| LED3602.V3| LED3602.V3|
LED3602.V3| LED3602.V3| LED3602.V3
---|---|---|---|---|---|---
Battery:| 3.7V 2.2Ah Li-Ion| 3.7V 2.2Ah Li-Ion| 3.7V 2.2Ah Li-Ion| 3.7V 2.2Ah
Li-Ion| 3.7V 2.2Ah Li-Ion| 3.7V 2.2Ah Li-Ion
Charging Time:| 3.5hr| 3.5hr| 3.5hr| 3.5hr| 3.5hr| 3.5hr
IP Rating:| IP54| IP54| IP54| IP54| IP54| IP54
LED Type:| 4W + 3W SMD| 4W + 3W SMD| 4W + 3W SMD| 4W + 3W SMD| 4W + 3W SMD| 4W
- 3W SMD
Lumen Output Side(High/Low)/Top:| (400/200)/120lm| (400/200)/120lm| (400/200)/120lm| (400/200)/120lm| (400/200)/120lm| (400/200)/120lm
Maximum Length:| 270mm| 270mm| 270mm| 270mm| 270mm| 270mm
Minimum Length:| 255mm| 255mm| 255mm| 255mm| 255mm| 255mm
Operating Time Side(High/Low)/Top:| (3/7)8hr| (3/7)8hr| (3/7)8hr| (3/7)8hr| (3/7)8hr| (3/7)8hr
Case Colour:| Red| Black| Green| Blue| Yellow| Carbon Fibre
IMPORTANT WARRANTY INFORMATION
The battery fitted to this light is considered to be a consumable item and its
ability to accept a charge will reduce over time. We will provide warranty
against mechanical and electrical defect for a period of one year – this does
not cover fair wear and tear. If the battery is not properly charged before
first use, or regularly conditioned, its capacity will diminish. Under these
circumstances we will not replace the battery regardless of whether the
battery less than one year old.
OPERATION
-
Connect the USB lead to the socket on the rear of the light. Plug into USB power supply and turn on, the charging LED
-
on the light will light RED to show that charging has commenced.
-
When the battery has fully charged the LED will turn GREEN.
-
Direct the lens away from your eyes before switching on.
-
Toggle the light between the end light and side light using the ON/OFF switch, The light may be suspended by the hooks or attached to any ferrous surface by using the magnets.
-
When the light is hanging from the hook it can be rotated through 360° for more precise positioning.
-
Separate the top and bottom sections by pulling apart. When attached to a ferrous surface, using the base magnet, the light can be rotated to shine in any direction.
Note: Mains charger not included.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
Register Your Purchase Here
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the
EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling
information.
NOTE: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
IMPORTANT: No Liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which is
required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk.
IP32 7AR
Tel: 01284 757500
Email :sales@sealey.co.uk
Website: www.sealey.co.uk
© Jack Sealey Limited
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>