LUCIDE 1xE27 SCOTT Wall Light User Guide

June 13, 2024
LUCIDE

LUCIDE-LOGO

LUCIDE 1xE27 SCOTT Wall Light

LUCIDE-1xE27-SCOTT-Wall-Light-PRODUCT-IMG

Product Information

Thank you for purchasing a Lucide original! Lucide aims to inspire and illuminate its clients by offering trendy, high-quality, and affordable lighting.

Discover Our Collection

Visit our website to explore our entire collection of lighting products. Our brand video provides a glimpse behind the scenes at Lucide, and you can also see how others around the world use Lucide products. Follow us for the latest lighting trends!

Safety Instructions

This product is only suitable for indoor use, excluding the bathroom (unless a higher IP degree permits its use in the bathroom).

  • IP 44: This product has a protection rating of IP44, indicating it is protected against solid objects greater than 1mm and water splashes from all directions.
  • Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Items marked with the recycling symbol should be returned to a municipal waste collection point.
  • Class I: This product has an earth connection. The green-yellow earth wire must be connected to the earth connection symbol.
  • Class II: This product is double insulated and must not be connected to the earth wire.
  • Class III: This product is only suitable for lower voltage supply and must not be connected to the earth wire.
  • IP 20: This product provides protection against contact with a finger.
  • If the protection glass is damaged or broken, it should be replaced immediately.
  • Please maintain a minimum distance between the bulb and inflammable objects.

Product Usage Instructions

Please follow the below instructions for the safe and proper use of the Lucide product:

  1. Ensure that the product is installed indoors, excluding the bathroom (unless specified otherwise by a higher IP degree).
  2. Connect the green-yellow earth wire to the earth connection symbol if the product has a Class I classification.
  3. If the product is Class II classified, do not connect it to the earth wire.
  4. If the product is Class III classified, ensure it is only connected to a lower voltage supply and not to the earth wire.
  5. Respect the minimum distance between the bulb and inflammable objects.
  6. If the protection glass is damaged or broken, replace it immediately.
  7. Follow all local legislation regarding the collection and recycling of electrical and electronic equipment.
  • Thank you for purchasing a Lucide original!
  • This manual will hopefully guide you easily through the installation process. We aim to inspire and illuminate our clients by offering trendy, high-quality and affordable lighting.
  • Welcome to the community of #illuminatesyourworld

RECOMMENDED LUCIDE LIGHT SOURCE

  • 49032/05/62
  • Dimmable: Yes
  • Included: No

General

  • Dimensions LxW×H: 20cm × 10 cm x 13cm
  • Main material: Metal
  • Ceiling rose material: Metal
  • Color: Black
  • Style: Vintage
  • Shape: Other
  • Weight: 0,22kg

Specifications

  • Dimmable: Yes
  • Light direction: Around (Diffuse)
  • Adjustable in height: Not In Height Adjustable
  • Directional: Not Directional
  • Cable: No Cable On Product
  • Sensor: Without Sensor
  • Control: Light Switch Control
  • Power supply: Adapter/Power Grid
  • IP-Class: 20
  • Electric Class: 1
  • Number of light sources: 1
  • Lamp socket: E27
  • Maximum wattage: 40 W
  • Power requirements: 220-240V-50Hz
  • Warranty: 2 Years

TECHNICAL DRAWING & DIMENSIONS

  • Item number: 45265/01/30
  • EAN code: 5411212450654

LUCIDE-1xE27-SCOTT-Wall-Light-FIG-2

For more specifications or dimensions of this product please visit www.lucide.com.

Installation Instructions

LUCIDE-1xE27-SCOTT-Wall-Light-FIG-3

Safety Instructions

  • Please read this notice carefully and keep it during the lifetime of this product. Follow the instructions for a safe and correct installation and functioning of the light fixture. The manufacturer does not accept any responsibility for damage caused by improper installation and service. Installation should always be done by a qualified electrician.
  • Always isolate the power before commencing installation, maintenance or repair.
  • In case of doubts, please contact a qualified electrician.
  • Please pay attention to locations where the item can be installed (indoor, outdoor, bathroom (for outdoor and bathroom installation, please see further). Indoor items cannot be used in humid places. Do not put the item in contact with water or any liquids or inflammable products. Always respect the minimal distance (indicated on the light) to inflammable products.
  • During installation, make sure that the cables will not be squeezed or damaged by sharp edges. If the external flexible cable is damaged, it needs to be replaced exclusively by the manufacturer, his service agent, or a qualified electrician.
  • This is to avoid all risks.
  • Because the temperature of the item and the bulbs can get very high, they must cool down before being touched. Always use the correct bulb (respect type and maximal wattage as indicated on the product).

symbols

Explanation of the symbols which can appear on the fixture

  • This item is only suitable for indoor use, exclusive bathroom (except if a higher IP degree permits that the item can be used in the bathroom).
  • Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and electronic equipment marked with this symbol indicating a separate collection of such equipment must be returned to a municipal waste collection point.
  • Class I: The item has an earth connection. The earth wire (green-yellow) needs to be connected to the earth connection (marked with this symbol).
  • Class II: The item is double insulated and must not be connected to the earth wire.
  • Class III: The item is only suitable for lower voltage supply and must not be connected to the earth wire.
  • IP 20: Protection against contact with a finger
  • If the protection glass is damaged or broken, it needs to be replaced immediately.
  • Please respect the minimum distance from the bulb to inflammable objects.

Warranty declaration

Lucide NV warrants that the products supplied will be free from defects in material and workmanship for a period of
2 years from the date of purchase by the end user, if the item is installed and maintained properly as mentioned in
the user manual.
Exclusions for the warranty

  1. Broken glass parts of the fixture will only be replaced within 14 days after purchasing by the end user.
  2. Normal wear and tear, and discoloring as a result of normal use.
  3. Damage is caused by external causes like fire, water, wrong use/ installation, or maintenance of the product.

For warranty claims, the customer needs to hand over the defective fixture/part and the original purchase ticket.

DISCOVER OUR COLLECTION!

  • Visit our website and discover our entire collection

CURIOUS ABOUT OUR BRAND?

  • Our brand video gives you a glimpse behind the scenes at Lucide

#ILLUMINATESYOURWORLD

  • Take a look at how others around the world use Lucide products

LUCIDE NV

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals