CTA PAD-PARAWM Prem Sec Wall and Desk Encl For Tab Instruction Manual
- June 13, 2024
- CTA
Table of Contents
CTA PAD-PARAWM Prem Sec Wall and Desk Encl For Tab Instruction Manual
CONTENTS
-
Security Enclosure
x1 -
x1
-
M5 Hex Screw
xb
- Security Lock Key
1x
-
4x
-
4x
-
M5 Allen Key
x1
- Security LockKey
x1
-
Foam Adapter & Sheet Bundle
x1 -
Anti-theft Security Cable
x1
INSTALLATION
Installing VESA Wedge to a Wall or Outlet
INSTALLING TO WALL / SURFACE
“Screwdriver for illustration and not included
1A. Pre-drill holes into wall using a power dill(not included). Then insert provided anchors (E). Align holes from VESA Wedge (B) to wall holes and rotate in screws (F) using a screwdiver (not provided) until securely tightened.
INSTALLING TO OUTLET
1B. Remove back provided tool (G) and unscrewing all (4) screws (C) as shown above.
Screwdriver for illustration and nonincluded
1C. Align holes from the front component of VESA Wedge (B) and tun in screws (F) using a screwdriver (not provided) until securely tightened.
Setting up Enclosure to Wedge
2A. With the wedge already attached to a surface, setup any needed wiring through the wallloutlet and wedge. It may also be just residing inside the wedge space interior as needed as well. (Not included). Make sure to fish out the wire from the wedge so it’s primed for connecting to the tablet device.
2B. Align VESA holes of tablet security enclosure (A) to that of the
wedge (B). Rotate in (4) screws (C) from the front using provided tool (G)
until securely fastened.
3A. Align enclosure holes (A) to VESA wedge holes (B) then tun in screws (C) using provided tool (G)
Setting up Device & Enclosure
Tablet shown for illustration and NOT INCLUDED.
3A. Lock or unlock your tablet enclosure with security key (H) as shown.|
38. Find the appropriate size foam padding (1) for the tablet you wish to
use. Make sure device is compatible for the enclosure. Lay in device and
connect any cables/cords as needed.
Tablet shown for illustration and NOT INCLUDED
3C. If needed, lay-in correct included masking insert (1). Close and lock
enclosure afterwards and you’re set
Anti-Theft Security Cable Setup
4A. Take the looped end of lock cable (K) and wrap it around the leg as
illustrated. Take the opposite end and fish it through the loop and connect it
to the k-slot location.
4B. Attach cable lock head (K) onto the enclosure k-slot location (A)
then insert provided key (J) and tum it clock-wise. Remove key to lock and
secure.
Adjusting Orientation
Rotate enclosure portrait or landscape to the preferred orientation,
36 Taaffe Place Brooklyn, NY 11205
support@ctadigital.com
888-733-4448
www.ctadigital.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>