HUINA 1585 12 Channel Remote Control Alloy Tower Crane User Guide

HUINA 1585 12 Channel Remote Control Alloy Tower Crane

• In order to more rapidly and freely operate the remote-controlled model, please read the instructions before usage.
• The packages and instructions contain important information, please keep them well.
• In case the product figure differs from real object, the real object will prevail.

THE TOWER CRANE TURNTABLE BATTERY INSTALLATION

• Open the tower crane turntable battery cover, install 7.2V charging batteries set,
• Cover the battery cover and tighten the screws.

BATTERY CHARGING INSTRUCTIONS

1. Connection LED lights lit;
2. Charging LED lights flash slowly;
3. Full LED light goes out;

TOWER CRANE BASE BATTERY INSTALLATION INSTRUCTIONS

Open the base battery cover, install 2X 1.5V “AA” batteries, and close the batteries cover, tighten the screws.

INSTALLATION OF REMOTE CONTROL BATTERY

Open the remote control battery cover, install 2X 1.5V “AA” batteries, and close the batteries cover, tighten the screws.

BATTERY INSTALLATION INSTRUCTIONS:

1. Take out and install battery correctly.
2. The non-rechargeable battery can’t be charged.
3. The rechargeable battery can only be charged under custody of adults;
4. Different batteries or new and old batteries can’t be used together;
5. Battery of same model or recommended model can be used;
6. The rechargeable battery should be taken out of the model before charging.
7. Battery should be placed with the correct polarity;
8. The exhausted battery should be taken out of model;
9. Short-circuit of batter terminal is forbidden:

REMOTE CONTROL FREQUENCY PAIRING AND POWER ON

• This product uses a 2.4GHz frequency remote control, before the play, should be on the remote control and the tower crane frequency matching;
• First tower crane and remote control to install the battery and turn on the power.
• At this point the remote will automatically find the frequency, and the indicator will blink.
• When the remote control indicator stops flashing, the Tower crane will issue a “beep” sound, and frequency matching completed. Press any key to start the tower crane sound effect, the remote control function can be used normally.

FUNCTION INTRODUCTION OF REMOTE CONTROL

FUNCTIONAL OPERATING INSTRUCTIONS

TOWER CRANE INSTALLATION

1. Mount the four mounting brackets to the bottom four corners of the socket.
2. Mount the tower to the seat.
3. Raise the tower connection.
4. The platform is installed to the tower.
5. Turntable installed to the platform.
6. Install the cone on the turntable.
7. Install the balance arm on the turntable.
8. With the hook to the cone with the end to withstand boom, balance arm connection.

BATTERY USE INSTRUCTION AND CAUTIONS

1. Batteries must be inserted with the correct polarity.
   • Do not mix different types of batteries or new and used batteries.
2. Only the recommended or the same types of batteries are used with the.
3.  The supply terminals can not be short-circuited.
4. Exhausted batteries must be removed from the car.
5. Non-rechargeable batteries should not be charged.
   • The batteries are only to be charged under adult supervision.
6. The batteries must be removed from the toy before charging.
7. The user needs to be regularly examined for damage to the wire and plug. shell and related parts, in the event of such damage, stop using until the damage has been repaired. Do not break off the antenna of the controller, or the sharp part may cut you.
8. The tower crane turntable uses a 7.2V chargeable battery set, Tower crane base uses a 2×1.5V “AA” alkaline non-rechargeable battery. R/C controller should use a 2×1.5V “AA” alkaline non-rechargeable battery.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>