HUINA 1583 RC Wheel Loader User Manual
- June 9, 2024
- HUINA
Table of Contents
HUINA 1583 RC Wheel Loader User Manual
OPERATION OF REMOTE CONTROL
INSTALLATION INSTRUCTIONS OF REMOTE CONTROL BATTERY
- Loosen the battery cover screw with a screwdriver and remove the battery cover.
- Load 2X1.5V “AA” batteries (batteries shall be purchased separately) into the battery box at the bottom of the remote control according to the correct polarity.
- Close the battery cover and tighten the screws.
BATTERY INSTALLATION
LOOSEN SCREW ON BATTERY COVER BY SCREWDRIVER, TWIST THE BUCKLE AND TAKE OUT BATTERY COVER.
CONNECTING WITH BATTERY BOX.
INSTALL THE BATTERY COVER.
BATTERY CHARGING INSTRUCTION
CHARGING METHODS
Connect the white port of Li-ion to USB charging port, as shown in the Figure,
and ensure port can be connected tightly and correctly, then insert the USB
charging plug into power adapter, and perform charging.
INDICATOR LIGHT STATUS AT THE TIME OF CHARGING:
Uncharged state: red light always lit Charged state: Red light always lit +
Green light flashes Full charging state: green light always lit Charging
period: 1-2 hours When battery is charged, please pull off the USB charger
lead in time.
Precautions Of Li-ion
- The battery must be charged with a dedicated USB charging cable.
- The USB charging cable must be connected to a 5V USB power adapter.
- Because the damaged lithium battery may ignite spontaneously, please do not charge it.
- The battery must be charged according to the specified method. If the lithium battery is used incorrectly, there is a high risk of spontaneous combustion.
Safe Usage Instructions for Li-ion
- If the lithium battery is used incorrectly, there may be a danger of spontaneous combustion.
- Our company will not be responsible for all losses caused by incorrect use of lithium batteries.
- Because it is likely to cause an explosion or fire, it is strictly prohibited to use a charger other than the original charging cable to charge the lithium battery. It is strictly forbidden to disassemble, bump, burn, reverse the positive and negative poles of the battery. Avoid metal objects and The positive and negative poles of the battery are in contact. It is strictly prohibited to pierce the battery with sharp objects to avoid the risk of battery fire.
- Please charge the battery within the visible range. Never stay away from the battery that is being charged.
- To prevent injury, keep the battery out of the reach of children.
- Please do not charge a damaged lithium battery. It may cause battery expansion, deformation, explosion or fire.
- In order to protect the environment, damaged batteries should be properly disposed of in accordance with regional or national waste regulations. deal with.
FREQUENCY PAIRING AND POWER ON OF REMOTE CONTROL
The product is remotely controlled with 2.4GHz frequency. For the first
operation, the user must install the battery on the vehicle body and the
remote control first, then make sure to power on, turn on the power to pair
the frequency automatically. When the indicator light of the remote control
stops flashing, the vehicle will make a lick” sound, that is, the frequency
pairing is completed. If the vehicle does not respond to the remote control,
the user can turn off the power of remote control and vehicle, turn on the
power of remote control and vehicle again to match again (same steps as
CONTROL OF LIGHT AND SOUND
THIS PRODUCT CAN REPRODUCE LIGHTS AND ENGINE SOUNDS.
DRIVING POERATING INSTRUCTION
SHOVEL POERATING INSTRUCTION
AUTOMATIC PRESENTATION
BATTERY PRECAUTIONS
- The car is equipped with 7.4V Li-ion battery pack; the remote control is equipped with 2X1.5V “AK batteries;
- The battery shall be removed and loaded correctly according to the polarity and voltage marks on the toy battery box; the battery shall not be shod-circuited;
- Non-rechargeable batteries cannot be charged;
- Rechargeable batteries must be charged under adult supervision;
- The rechargeable battery shall be removed from the toy before charging;
- Different types of batteries or old and new batteries cannot be mixed;
- Only batteries that are the same as or equivalent to the recommended batteries can be used;
- The exhausted battery shall be removed from the toy. If the toy is not used for a long time, please remove the battery from the toy;
- The power terminals must not be short-circuited;
- The battery charging time is about 1-2 hours;
- It cannot be connected to more than the recommended amount of power sources. During the use of the USB charging cable, check its wires, plugs, shells and other components regularly for damage. If damage is found, stop using it until the repair is complete.
DON’T IMPROPERLY USE THIS PRODUCT
Don’t willfully dismantle, modify or process it. For any modification and
mainte-nance, please use the parts list in product content to ensure structure
safety. Please operate products within specified limit, overload is forbidden,
and illegal purposes in violation of safety order are forbidden too.
IMPORTANT NOTICES
Note! The products are manufactured by batches after performances have been
strictly demonstrated and practically tested to verify meeting safety
standards, but personnel below 8 are forbidden to use it. For any use of
remote-controlled model, the manufacturer or dealer won’t bear any
responsibility for accidents resulted from abnormal parts usage and wearing,
improper assembling or operation under unsafe environment. Please be sure to
operate this product under safe environment. This company won’t bear property
loss and personal injury resulted from improper
operation/dismantling/modification on sold product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>