ENSTO ECO500 Frost Protection Thermostat Instruction Manual
- June 13, 2024
- ENSTO
Table of Contents
ENSTO ECO500 Frost Protection Thermostat Instruction Manual
Installation and Operating Instructions
ECO500 is an electronic thermostat for frost protection of drain pipes.
Safety Instructions
Electrically skilled person
- The installation must only be done by an electrician with the appropriate qualifications.
- Follow the instructions in this manual, and make sure that the installation complies with national safety regulations, installation methods and restrictions.
- The information provided in this manual in no way exempts the installer or user from responsibility to follow all applicable safety regulations.
- Keep this manual for future installation and service.
WARNING
Danger of electric shock! Risk of fire!
- Disconnect the power supply before carrying out any installation or maintenance work on this thermostat and associated components.
- Do not switch on the power supply before the installation work is completed.
- Improper installation can cause personal injury and property damage.
- Do not operate a defect thermostat.
Installation Instructions
- Install the thermostat in accordance with figures 1 and 2.
- Attach the sensor outside the pipe on the opposite side of the heating cable, and in such a manner that it measures the coldest spot of the pipe.
- A residual circuit breaker must be used in accordance with the local installation regulations.
User Instructions
- Set the temperature by turning the adjustment wheel, figure 1.
Switch off the power before you remove the thermostat cover!
Warranty
The warranty period for Ensto ECO thermostats is 2 years from the date of purchase but no longer than 3 years from the date of manufacture. Warranty conditions, see www.ensto.com/building-systems
Disposal
Do not dispose of electrical and electronic devices including their accessories with the household waste.
The product’s cardboard packing is suitable for recycling.
When a heating system is at the end of the life cycle the cables, conduits and
electronic components must be disposed of properly according to local
recycling guidelines.
Technical Data
Rated voltage : 230V/50Hz, -15%/+10%
Adjustment range: +2 … +35 ºC
Load (max): 3600W, 16A cosφ = 1 / 2A cosφ = 0,4
Nominal current: 16A
Sensor: NTC / cable 4m, extendable, max 50m (2 x 1,5 mm2)
Sensor resistance values: Table on page 2 (sensor is not connected)
Ambient temperature (ta): -30 … +30 ºC
Ingress protection: IP55
Ensto Building Systems Finland Oy
Ensio Miettisen katu 2, P.O. Box 77
FIN-06101 Porvoo, Finland
Tel. +358 204 76 21
www.ensto.com/building-systems
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>