MILOO IP40 BASSO SUPER SLIM luminaires Instruction Manual
- June 13, 2024
- MILOO
Table of Contents
INSTALLATION AND OPERATION INSTRUCTIONS
IMPORTANT
Installation of the luminaire should be carried out by a duly authorised
person.
SAFETY INSTRUCTIONS
Before proceeding to any work on the luminaire, always switch off the supply voltage first!
INTENDED USE:
BASSO SUPER SLIM luminaires are designed to illuminate the place of work,
office rooms, conference halls and corridors. Depending on the version
selected they can be installed in coffered ceilings, flush or surface mounted.
LUMINAIRE INSTALLATION PROCEDURE:
When installing luminaires in a coffered ceiling, always make sure to check the load bearing capacity of the ceiling and the weight of the luminaires to be installed. To relieve the strain on the ceiling, it is recommended to fix the BASSO SUPER SLIM luminaires on 2 to 4 wires (not included) to a solid ceiling or a permanent construction.
Installation details for flush-mounted and surface-mounted versions Figure 1. Securing the flush-mounted flange in the ceiling
Figure 2. Securing the base luminaire in a frame before installing in a flush- mounted flange or a surface-mounted housing.
Figure 3. Fixing the mandatory safety wire for surface-mounted versions
Figure 4. Mounting of luminaire in a flushmounted flange or a surface-mounted
housing
CONNECTION DIAGRAMS:
When installing, pay attention to the factory markings on the luminaire and wire colours
MAINTENANCE:
To ensure optimum luminous flux, carry out routine maintenance of the protective lampshade. Use cleaning agents for this purpose. Do not clean with pressurised water. Do not use caustic agents or solvents. Use a soft cloth to wipe the luminaire dry.
PRODUCT GUARANTEE:
- The following product of MILOO-ELECTRONICS Sp. z o. o. was designed and manufactured as per the applicable standards. To ensure proper functioning and user safety, the product is subject to quality control procedures during the production process. MILOO-ELECTRONICS Sp. z o. o. grants a guarantee of proper quality and functioning of the luminaire.
- The guarantee does not include liability for consequential damage caused to third party property.
- The guarantee service involves repair or replacement of defective parts at manufacturer’s discretion.
- The guarantee will not cover damage to parts subject to wear and tear, damage and malfunctions caused by improper operation or maintenance.
- During the guarantee period, the manufacturer will correct any deficiencies caused by defects in material or workmanship.
- The guarantee is valid only if the luminaire (complete rather than disassembled into parts), a brief description of the defect, receipt, bill of sale (with the date of purchase and stamp of the store) or a copy of the purchase invoice is sent or delivered to MILOO-ELECTRONICS Sp. z o. o. location.
For general guarantee terms and conditions visit:
https://www.emiloo.pl/en/files
REPAIR SERVICE:
In case of defects subject to guarantee, please send or deliver the product to
the address of our company. Any repairs of defects outside the scope of
product guarantee as well as post-guarantee repairs are carried out by our in-
house service team. Please send or deliver the luminaire to the manufacturer’s
address for visual inspection and cost estimate.
The light source used in this luminaire should only be replaced by the
manufacturer or its service representative, or a similarly qualified person.
Given the constant product development we reserve the right to introduce
design changes in luminaires and update luminaire parameters.
Revision date: 15.10.2021
https://www.emiloo.pl/en/files
MILOO-ELECTRONICS Sp. z o. o.
Stary Wiśnicz 289
32-720 Nowy Wiśnicz
tel: +48 14 662 19 55
biuro@emiloo.pl
www.emiloo.pl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>