ROBENS YURT Inflatable Aero Tent Instruction Manual

: June 13, 2024
: ROBENS

Table of Contents

Congratulations on your new Robens tent, designed and created to
Assembling and Pitching the tent
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ROBENS YURT Inflatable Aero Tent Instruction Manual

Congratulations on your new Robens tent, designed and created to

accompany you out into the great outdoors

When selecting your campsite, the ideal place would be an area as even and clean of rocks, branches and other sharp objectsas possible, and avoid placing the tent directly under trees.

Assembling and Pitching the tent

Spread the floor and flysheet on the ground, locate the starting points of the connection zipper on the floor and flysheet and zip them together all around.
Tension the floor in all directions and fasten it provisionally with pegs.
Assemble the frame using only 4 legs, as illustrated.
Carefully move the frame into the tent: One person holds the door/ flysheet and another pulls the frame in
Attach the remaining two legs and fasten them in the roof using the hook & loops. Place the pole feet in the dedicated pockets.
Extend the 6 legs one by one in two rounds and fasten them around the sides using the hook & loops
Finally, peg out and tighten allguylines and pegging loops for\ equal tension.

Please turn over for more tips and information.

Check out www.youtube.com/ user/Robenstents for pitching film and tips.

Cleaning and maintenance tips
Get the most out of your camping trip by having a trial run, putting up and taking down your new tent in order to know it before you use it for the first time.

Under certain weather conditions, condensation can occur on the inside surfaces of your tent. To help prevent this you must remove wet clothes etc., increase ventilation or erect your tent on a PVC mat.

Be aware that (UV) ultraviolet rays will damage your tent if you expose it to direct sunlight for longer periods of time. Robens Products are made for camping use which is normally 5-8 weeks usage a year. They are not designed for permanent usage and should only be used as camping products. Camping near the sea or lake can further enhance the effect of UV radiation. The same applies to poles and metal parts.

Condensation should not be confused with leakage
The flysheet is made of waterproof material. To prevent water from seeping through the flysheet avoid touching the inside surface in rainy weather conditions

When erecting your tent, do not secure it too tightly, otherwise it will not be able to adapt to varying wind and weather conditions.

If strong winds are expected, replace the normal tent pegs with storm pegs. Do not use guylines to pull out the tent pegs. For stony or hard ground stronger U-form pegs are recommended

Insecticides must not be sprayed in or on the tent as they may damage the fabric and coating!
When taking down and packing the tent, it must be completely dry to avoid mildew/rotting. We recommend that after use all metal poles be lightly greased with a nonacidic oil.

Remove dirt from the tent with a soft sponge and pure water. Never wash the tent in a washing machine and never have it dry-cleaned.

Store the tent in a dry place.

Even though we have used special waterproof thread for all seams, we recommend that you use a seam sealer or a waterproof spray at regular intervals for all seams around the zips and toggles, these seams are some of the weaker points on your tent as there can be a lot of tension around them

Please note that the tape may come off after prolonged exposure to the sun. If this happens you can repair your tent by removing loose tape and use a seam sealer and waterproof spray to re-seal seams. Be aware that (UV) ultraviolet rays will damage your tent if you expose it to direct sunlight for longer periods of time.

If your tent has a mud valance never
use it to adjust the tent or use the mud valance to pull the tent pegs out. The mud valance is one of the weaker

points on the tent as it is only designed to keep wind and water out of the living and storage area

Taking down your tent
When detachable take out the

groundsheet and clean it if necessary with a sponge and water. Clean dirty floors the same way. (Allow it to dry before packing the tent). If the inner tent is wet or dirty, take it out and clean it, the tent can be packed down with or without the inner tent inside.

Then start to unpeg the tent and the guylines. Gently remove the poles from the pins and then gently push the poles through the sleeves. Do not pull thepoles through!

You are now ready to fold the tent. Try to fold it so you have all metal pins/ rings at one side (to prevent them from making holes in the flysheet

When you have folded the tent, measure it with the carrybag to make sure it is not too wide. You should now be able to roll the tent round the poles in their pole bag and fit it into the Robens carrybag