SUNGROW SG5.0RT 3 Phase PV Inverter Installation Guide
- June 13, 2024
- SUNGROW
Table of Contents
SUNGROW SG5.0RT 3 Phase PV Inverter
Product Information
The 3 Phase PV Inverter is available in various models:
- SG5.0RT
- SG6.0RT
- SG7.0RT
- SG8.0RT
- SG10RT
- SG12RT
- SG15RT
- SG17RT
- SG20RT
This product features the following updates:
- Addition of relevant standard functions for countries Finland,Denmark, Netherlands, and Belgium.
- Optimization with Italian self-test.
- Addition of 1.1 times overload capability for country Belgium(except SG10RT model).
Validity Period: May 27th, 2023
Firmware: BERYL-S_B000.V000.P024-20220429 or above
Detail version: BERYL-S_03011.01.39 & BERYL-S_01011.01.23 or above
Product Usage Instructions
To use the 3 Phase PV Inverter, follow these steps:
- Ensure that the firmware of the inverter is at least version BERYL-S_B000.V000.P024-20220429 or above.
- Connect the PV (Photovoltaic) system to the inverter according to the installation guidelines provided.
- Make sure to use the appropriate model of the inverter based on your power requirements:
- SG5.0RT for power up to 5.0 kilowatts.
- SG6.0RT for power up to 6.0 kilowatts.
- SG7.0RT for power up to 7.0 kilowatts.
- SG8.0RT for power up to 8.0 kilowatts.
- SG10RT for power up to 10 kilowatts.
- SG12RT for power up to 12 kilowatts.
- SG15RT for power up to 15 kilowatts.
- SG17RT for power up to 17 kilowatts.
- SG20RT for power up to 20 kilowatts.
- If you are using the inverter in Finland, Denmark, Netherlands, or Belgium, ensure that the relevant standard functions are enabled.
- If you are using the inverter in Italy, perform a self-test to optimize its performance.
- Note that the SG10RT model does not support 1.1 times overload in the country of Belgium.
For any further assistance or troubleshooting, refer to the complete user manual or contact our customer support.
INSTRUCTION
June.2nd, 2022 Feature Update
Valid till:
May.27th, 2023
Firmware:
- Installation package: BERYL-S_B000.V000.P024-20220429 or above
- Detail version: BERYL-S_03011.01.39 & BERYL-S_01011.01.23 or above
Updated log:
- Add relevant standard functions of countries (Finland, Denmark, Netherlands, Belgium). Optimize with Italian self-test.
- Add country Belgium 1.1 times overload (except SG10RT)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>