Canon TR8600 Wireless All-In-One Inkjet Printer User Guide

Table of Contents

Canon TR8600 Wireless All-In-One Inkjet Printer User Guide

Online Setup
https://ij.start.canon

Remove and dispose of any protective film and orange tape.
- Using the printer with orange tape or protective film still attached, may cause the printer to malfunction.
Open the scanning unit / cover and remove the orange tape.
Close the scanning unit / cover.

Caution
Watch your fingers.

Open the scanning unit / cover.

Caution
Do not touch the print head holder until it stops moving.
Remove the tape and film on the ink tank.
- Check that no tape or film is left.
Slowly remove the orange cap.

Important
- Do not squeeze the ink tank with the Y-shaped air hole blocked.
- Do not touch the areas shown in red.
Install the ink tank.
- Insert the ink tank into the print head and press down until it clicks.
Check that the color of the ink tank you installed appears on the screen.

Important
If the color is not displayed on the screen even though you have installed the ink tank, the color of the ink tank may be wrong or you may have installed an ink tank, such as one with a different model number, that is not supported by this printer. Either install an ink tank for the correct color or use the provided ink tank for setup.
Repeat steps 2 through 5 to install all the ink tanks.
- Check that all the colors appear
Close the scanning unit / cover.
- The printer will start initializing.

Caution
Watch your fingers.

Tap OK.
Remove the cassette from the printer.
Remove the cassette cover.
Slide apart the paper guides.
- Slide the right paper guide to the right edge. Align the front paper guide with the Letter mark.
Load Letter sized plain paper.
- Place the paper against the front paper guide, and align the right paper guide to the width of the paper.
Attach the cassette cover and replace the cassette.
Pull out the paper output tray.

Tap **OK.

**
- The Print Head Alignment pattern starts printing.
Check that the pattern is printed.
Place the pattern on the platen.
- Open the document cover and place the print side facing down.
  
  Align the arrow mark on the device and the on the pattern
Close the document cover and tap OK.
When the following screen appears, tap OK.
Tap Next.
- Follow the on-screen instructions to continue setup. This includes making selections related to sending information.
  Refer to “Sending Information To Canon” in Safety and Important Information.
Check that the following screen appears.

If you will use the printer without connecting any other devices, setup is now complete.

Select the connection method that best matches how you will use the printer.

To use the printer without connecting to any other devices
- Setup is now complete.
  To set up a fax, see “Using Fax Function” on page 8.
To use the printer connecting to a computer or smartphone
- Proceed to the next page.

If you are using multiple computers, perform these steps on each computer.

Access the Canon website from your computer.
https://ij.start.canon
Select Set Up.
Enter your printer’s model name and click Go.
Click Start.
Click (B) Connecting to a Computer/ Smartphone.
- The following steps are for Windows users.
Click Download.
Run the downloaded file.
Click StartSetup.
Follow the on-screen instructions.
- These operations may take some time.
- To connect to a smartphone as well, see “7-b. Connecting to a Smartphone” on page 7.
- To set up a fax, see “Using Fax Function” on page 8.

Photo paper can only be loaded in the rear tray.

Open the rear tray cover and extend the paper support.
Open the feed slot cover and slide the righth and side paper guide to the far right.
Load several sheets of photo paper with the print side facing up and slide the side paper guide against the edge of the paper stack.
Close the feed slot cover.
- Follow the on-screen instructions to set information for the loaded paper.