RALPH LAUREN RL2270 Annette Library Light User Guide
- June 4, 2024
- ralph lauren
Table of Contents
RL2270 Annette Library Light
User Guide
ASSEMBLY INSTRUCTIONS
Anette Library Light Item # RL2270
NOTICE: This light fixture should be installed in accordance with all
applicable, local installation codes, and by a person familiar with the
construction and operation of it, as well as the hazards involved. Inspect
items and contents carefully. If any damage or defect is found, do not install
it. Retain all packaging material until installation is complete and approved.
-
Carefully remove all parts from the carton.
-
Remove mounting plate (A) from the base of the light fixture (C) by removing base screws (D) in a counter-clockwise direction.
-
Affix mounting plate (A) to wall outlet box with mounting screws (B) provided.
-
Attach ground (green or green/yellow) wire to ground wire from the wall outlet box (usually green or copper in color ), and fasten it together with a plastic wire connector. Tightly wrap the wire connector with electrical tape. So the end of the connector is sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
-
Connect the neutral (white ) fixture wire coming from the fixture base to the neutral (usually white ) outlet wire. Fasten both wires together with a plastic wire connector and tightly wrap the wire connector with electrical tape.
-
Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are left outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE COMPROMISED.
-
Attach fixture base (C) to the affixed mounting plate (A) and secure with base screws (D).
-
Attach lamp shade (H) to top threaded section of socket housing (G) by turning (H) in a clockwise direction.
-
Insert the light bulb into the socket.
-
Installation is complete. Restore power and test fixture.
ADJUSTMENT INSTRUCTIONS
- Loosen adjustment keys (E).
- Adjust lamp poles (F) and sockets (G) to the desired position.
- Tighten the adjustment keys (E).
Care Instructions:
Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.