ENDON 106792 Table Light Instruction Manual

ENDON 106792 Table Light

Product Information

This table light is designed for indoor use only and operates on a 220-240V~ 50Hz power supply. It is important to follow the safety instructions provided to ensure proper installation and usage of the product.

Safety Warnings

• Read and retain these instructions for future reference.
• If you are unsure about installing the product, consult a qualified electrician.
• Do not use this product in a bathroom location.
• Ensure that the lamp is protected by a 3 amp fuse in the mains plug.
• Only use bulbs with wattage specified on the label to prevent damage to the fitting.
• Avoid placing or hanging anything on the product.
• If the external cable or cord is damaged, contact a qualified electrician for replacement.
• Dispose of waste electrical products through recycling facilities.
• These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
• This product is only suitable for connection to a 220-240V~ 50Hz supply. It is for indoor use only, and not suitable for a bathroom location.
• This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth.
• Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance. this product must be used on a stable, flat surface.
• Under no circumstances must this lamp be covered with any material as this could pose a safety hazard.
• This product is not a toy and not suitable for persons under 14 years of age.
• This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.
• The lamp must be protected by a 3 amp fuse in the mains plug.
• Never fit bulbs of a higher wattage than those specified on the label as these may damage the fitting.
• Never put anything on the product or hang anything on any part of this product.
• If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified electrician to avoid any electrical hazards.
• Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
• Check with your Local Authority or local store for recycling advice.

Care and maintenance

For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use). Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Troubleshooting

When the bulb does not light after installation:

• Please plug in and operate the switch to turn your lamp on.
• Please check the bulb.
• Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box.

If you have any doubt about the installation/use of this product, consult a qualified electrician.
To use this item in Europe, the 3-pin adaptor can be removed by loosening the central screw and removing the adaptor to reveal the 2-pin Europe plug.

Scan QR code for multi-language:

UK Manufacturer: BH17
EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>