Cloud CS-S3 3 Inch Surface Mount Loudspeaker Installation Guide
- June 13, 2024
- CLOUD
Table of Contents
Cloud CS-S3 3 Inch Surface Mount Loudspeaker
The CS-S3 3 Surface Mount Loudspeaker is a high-quality speaker designed for
installation in various settings.
This speaker provides clear and powerful audio, making it suitable for both
indoor and outdoor applications.
With its compact design and versatile mounting options, the CS-S3 is easy to
install and integrate into any audio system.
Product Specifications
- Tap Settings: 1, 2, 3, 4, 5, 6
- Compatible Voltage: 100V, 70V, 25V
- Impedance: 16 ohm
- Power Handling: 16W, 8W, 4W, 2W, 1W, 0.5W, 0.3W, 0.2W
Installation Guide
- Remove the speaker from the box.
- Mount the bracket to the wall using appropriate screws and tools.
- Locate the tap switch on the back of the speaker and set it to the proper setting. Note that the tap switch is initially set to the highest 100V position.
- Insert the euroblock connector into the rear of the speaker.
- Connect the signal wire to the euroblock connector. For daisy chaining multiple speakers, use the LINK output to connect to the next speaker.
- Snap the speaker onto the mounted bracket.
- To adjust the speaker’s angle, rotate the enclosure or base until the desired angle is achieved.
For any servicing or maintenance needs, it is important to consult a qualified
speaker technician. The CS-S3 speaker does not contain user-serviceable parts.
For more information and support, visit
www.cloud.co.uk or
www.cloudusa.pro.
- CAUTION – Installation
- Speaker must be installed by qualified speaker technician.
- CAUTION – Servicing
- Do not perform servicing unless you are qualified to do so. The unit contains no user-serviceable parts. Refer servicing to qualified personnel.
- CAUTION – Tap Switch
- Before use check and set tap switch under grille to proper setting for your system.
EXPLODED VIEW
TAP SETTINGS
| Tap | CS-S3 |
|---|---|
| 100 V | |
| 1 | 16 ohm |
| 2 | X |
| 3 | 16W |
| 4 | 8W |
| 5 | 4W |
| 6 | 2W |
INSTALLATION
- Step 1 Remove speaker from box.
- Step 2 Mount bracket to wall.
- Step 3 Locate euroblock in accessory bag and connect signal wire. For daisy chaining, use “LINK” output to run to next speaker.
- Step 4 Set tap switch located on back of speaker to proper setting. Tap switch is preset to highest 100V position.
- Step 5 Insert euroblock into rear of speaker.
- Step 6 Snap speaker onto bracket.
- Step 7 To aim speaker rotate enclosure or base to achieve desired angle.
- www.cloud.co.uk
- www.cloudusa.pro
Documents / Resources
|
Cloud CS-S3 3 Inch Surface Mount
Loudspeaker
[pdf] Installation Guide
CS-S3W, CS-S3B, CS-S3 3 Inch Surface Mount Loudspeaker, Surface Mount
Loudspeaker, Mount Loudspeaker, Loudspeaker
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>