Cloud Defensive MCH-2.0-DF Flashlight User Guide
- October 30, 2023
- Cloud Defensive
Table of Contents
MCH-2.0-DF Flashlight
User Guide
GENERAL OPERATION
MCH is very versatile. With a variety of ND protection configurations, pocket
clips and light heads, it is highly modular, flexible and even upgradeable
moving forward.
Electrically, the MCH has a very unique operating system. It utilizes a direct
drive solution that results in differing amounts of performance based on the
battery you choose. Some batteries will have more output than others. Some
will have more run-time than others. Always use name-brand, approved
batteries. See Battery Warning section for list of approved batteries.
MCH will function with both flat-top or button top, protected or unprotected
rechargeable cells. Some protected cells may be too long however.
Specifically, the cells with an integrated Micro USB port.
Each MCH is fitted with a push-button tail cap switch. The switch features
both momentary and constant-on capability. A shallow press and hold will give
you momentary. A full click will give you constant-on. Then just click to turn
off.
Simple. Powerful. Configurable. Everything a handheld light should be.
NEGLIGENT DISCHARGE PROTECTION SYSTEM
The MCH utilizes an industry-first feature that prevents accidental or
negligent discharge of the light. Each MCH ships with 3 different ND
Protectors that simply thread into the tail cap. They are replaceable at any
time, should you want to adjust things.
To install the ND Protector:
- Choose the ND Protector that is right for you
- Carefully thread it into the top of the tail cap
- Hand-tight is all you need.
- Installation is complete.
POCKET CLIP INSTALLATION
The MCH uses a compression fit between the light body O-ring and the pocket clip itself to secure the pocket clip to the light. Installation is simple.
- Unscrew the tail cap and remove it.
- Remove the smaller o-ring that is closest to the top of the light body.
- Slide the pocket clip of choice onto the light body. Push it all the way down until it seats.
- Place the larger included O-ring onto body above the clip.
- Place the removed smaller O-ring back on the body where it originally was.
- Replace the tail cap and tighten it down until it is fully-seated.
- Installation is complete
BATTERY INSTALLATION
The battery can be installed from the front or back of the light, based on
your need. As a rule, it’s easier to install the battery through the front.
To install the battery:
- Remove the head (recommended) or tail.
- Insert the battery. Positive terminal must go towards the head.
- Put the head or tail back on and hand-tighten.
- Installation is complete. Enjoy your MCH.
MAINTENANCE
The o-rings on either side of the body: like all o-rings, can and will eventually fail. To prolong their life, periodically apply a small amount of non-petroleum based lubricant. Replacement o-rings can be purchased through www.clouddefensive.com
BATTERY WARNING
USE 18650/18350 RECHARGEABLE CELLS OR CR123A: Mission Configurable Handheld is
rated for a single 18650 rechargeable battery or two CR123A batteries. MCH can
use both protected and unprotected cells in both button top and flat-top
configurations. MCH Micro is rated for a single 18350 battery or single CR123A
batter.
WARNING: The Mission Configurable Handheld is the most advanced handheld
light available. One of those critical (but unseen) advancements is our
ability to create a substantially better “heat sync”. Heat sync helps the
system cool.
However, MCH is also very powerful. So this light will get uncomfortably hot
to the touch during extremely high rates of sustained use. This is generally a
nonissue for the end-user. But this light can become hot enough during certain
conditions that it could trigger a “drop response”.
APPROVED BATTERY MANUFACTURERS:
CLOUD DEFENSIVE/SAMSUNG/PANASONIC/LG/SANYO/SONY/KEEPPOWER
Buyer has read the warnings on the product page(s) and clearly understands the
potential dangers of using unprotected cell batteries. Unprotected cell
batteries have more capacity and current capability than a protected cell
battery. Buyer understands that unprotected cell batteries provided by Seller
are only to be used in light applications manufactured by Seller. Buyer
understands that use of unprotected cell batteries can result in property
damage, serious bodily injury and/or death. All unprotected cell batteries can
explode, catch fire, and potentially cause injuries if pierced, cut, smashed,
short-circuited, burned, disassembled, recharged, dropped or used or stored in
extreme temperatures. For performance purposes, the unprotected cell batteries
provided by Seller do NOT contain a built-in fault or heat protection. Buyer
understands unprotected cell batteries should be stored or kept in a protected
casing or in the proper light application and should not be kept or stored
loose in a pocket, purse, backpack or otherwise and should be kept away from
metal objects to prevent short circuiting. Buyer understands when not in use,
the unprotected cell batteries should ALWAYS be stored in a secure, dedicated,
and non-conductive battery case. Buyer understands if an unprotected cell
battery is damaged in any way, Buyer should stop using said battery
immediately. Do not charge the unprotected cell battery unattended.
Immediately discontinue use of the unprotected cell battery if, while using,
charging or storing said battery, the unprotected cell battery emits an
unusual smell, feels hot, changes color or shape, or appears abnormal in any
way. Only use the unprotected cell battery charger provided by Seller to
charge the unprotected cell battery. Always keep the unprotected cell
batteries away from children.
CALIFORNIA PROPOSITION 65
WARNING: This product contains the following ingredients for which the
State of California has found to cause cancer, birth defects or other
reproductive harm, which would require warning under the statute – Lithium
Nickel Manganese Cobalt Oxide, Lithium Cobalt Oxide, and others. See
www.p65warnings.ca.gov for more information.
PLEASE DISPOSE BATTERIES PROPERLY
PROGRAMMING INSTRUCTIONS
Your new MCH light is now user-programmable. It ships from the factory with 5
dedicated modes to choose from. You can change the operational mode at any
time. And the light will remember the mode you select even during a battery
change.
Mode 1: (High-Only) 100% power
Mode 2: (Low/High) 10% power, 100% power
Mode 3: (High/Low) 100% power, 10% power
Mode 4: (Very Low/Medium/High), 5% power, 30% power, 100% power
Mode 5: (High/Medium/Very Low) 100% power, 30% power, 5% power
HOW TO ENTER CONFIGURATION MODE & CHANGE GROUPS:
NOTE: The program mode/clicks reset after the light has been on for ~3
seconds and after the light has been off for ~3 seconds, so it is unlikely you
will ever accidentally enter configuration mode during normal use.
NOTE: Every time you enter configuration again once exited all the way
out, you go back to group 1 and count up again.
- Rapidly click the switch until the light begins to strobe to enter configuration mode. It isn’t necessary to count the clicks.
- The light will strobe briefly to let you know you have entered configuration mode.
- Once the quick strobe stops, the light will “blink out” the number of the mode group you are going to select.
- After the “blink out”, the light will start to ramp up.
a. If you want to go to the next mode group, simply turn off and turn the light back on during this period.
b. If you want to select the mode group that was blinked out, either wait until the light ramps all the way up (configuration mode will exit) or turn the light off and wait ~3 seconds.
LIFETIME WARRANTY
We warranty our stuff for life. And yes, we know these are hard-use tools. If a company in this line of work won’t stand behind their stuff, you probably should not buy it. We stand immovable behind our products. MCH is no exception. There are a few things however we can not warranty on the MCH.
- Compromised electrical system from incorrect batteries. The afore-mentioned instructions and packaging of the unit itself makes its ABUNDANTLY clear that you can ONLY use an 18650/18350 or CR123A battery. If you use a different battery, you will compromise the electrical system. So know your equipment, be smart and do NOT put any other batteries into this system. If you have questions, contact us. We’re always here to help.
- Broken lens. In the event that your MCH lens breaks, please email pictures to us at support@clouddefensive.com. We will fix or replace as needed on a case by case basis.
- Normal wear and tear. Cosmetic damage and standard wear/tear from use comes with the turf with this kind of equipment. If you think something is excessive let us know and we’ll evaluate it but we have to reserve the right to reject a warranty claim on cosmetic issues.
- Compromised electrical system from water ingress. The MCH is waterproof and even submersible. But if you take the head or tail off the MCH and get water inside the disassembled components, the electrical system can become damaged. We can’t warranty that. So just keep the MCH fully assembled when exposed to water and you’ll be fine. If our seals fail and water damage is sustained because of those seals failing, we will absolutely warranty that.
- Compromised electrical system from unauthorized disassembly of the MCH. Some parts of the MCH that are permanently sealed during the manufacturing process. If you disassemble the light head or the tail cap cartridge, your warranty is void. So basically, don’t intentionally take your MCH apart beyond normal maintenance.
Simply said, big boy rules apply with the warranty. If you follow those rules,
we have your back on the MCH. Forever. If you mess it up due TO NEGLIGENT
operating procedures or due to unauthorized disassembly – that is on you and
the warranty is void.
In the event that you void the warranty, contact us at
support@clouddefensive.com and tell us
what happened. We will be happy to repair your light at the lowest price
possible.
WARRANTY CLAIMS
Cloud Defensive stands, unequivocally, behind it’s products. We will warranty
this product for life with only exceptions for the above-listed user-induced
issues. If our craftsmanship causes an issue, we’ll fix it for life. If the
unit fails under use and the warranty-voiding issues listed above are not
present, we’ll fix it. This is a world-class weapon light. You can expect
world-class service in the event you need it.
If you need to send your MCH in for a tune-up, simply email us at
support@clouddefensive.com AND identify
the issue with the light. You must be issued a RMA# prior to shipping.
DISCLAIMER
Unless specified here or prohibited by applicable law, all express or implied
conditions and warranties, including and without limitation, any implied
warranty or condition of merchantability or fitness for a particular purpose,
or accuracy
of any informational content, are hereby excluded and disclaimed by Cloud
Defensive LLC, and in no event will Cloud Defensive LLC be liable for any
special, direct, indirect consequential, incidental or punitive damages
whatsoever arising and regardless of the theory of liability, even if advised
of the possibility of such damages. Products, pricing, availability,
specifications and offers are subject to change or cancellation at any time,
without notice.
PLEASE VISITWWW.CLOUDDEFENSIVE.COM FOR
COMPLETE TERMS & CONDITIONS
JOIN US
facebook.com/clouddefensive
youtube.com/clouddefensive
@clouddefensive
We love seeing your pictures on social media. Please tag us on Instagram.
SUPPORT
support@clouddefensive.com
Cloud Defensive
6045 Wedeking Avenue Unit E
Evansville, IN 47715
www.clouddefensive.com
MADE IN THE USA
LIFETIME WARRANTY
Documents / Resources
|
Cloud Defensive MCH-2.0-DF
Flashlight
[pdf] User Guide
MCH-2.0-DF Flashlight, MCH-2.0-DF, Flashlight
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>