spaDepot SPA BLANKET ThermoFloat Blanket Instructions
- June 13, 2024
- spaDepot
Table of Contents
spaDepot SPA BLANKET ThermoFloat Blanket
Product Information
The ThermoFloat Spa Blanket is designed to provide insulation and reduce heat loss for your spa. This bubble-style blanket is made from durable materials that help retain heat and prevent evaporation. The blanket is easy to trim and customize to fit your specific spa dimensions.
Product Features:
- Helps retain heat and reduce heat loss
- Prevents evaporation
- Bubble-style design for added insulation
- Durable and long-lasting materials
- Easy to trim and customize
Product Usage Instructions
- Using a tape measure, determine the inside surface dimensions of your spa at the waterline.
- Add about 2 inches to each dimension and record the new measurements.
Length + 2: ____ inches
Width + 2: ____ inches
Note : Adding extra inches helps prevent the blanket from shifting during the hot tub’s filtration cycle.
- Lay the ThermoFloat blanket, bubble-side down, on a flat surface such as your lawn or indoors on a floor.
- Mark the recorded dimensions on the smooth side of the blanket using a marking pen.
- Trim the blanket to rough size, following the marked length and width using scissors.
- Place the roughly-trimmed ThermoFloat blanket in your filled spa, bubble-side down.
- Using the marker, trace around rounded corners and any other spa features that require a cutout or additional trimming.
- Trim the blanket again as needed with scissors to match the traced markings.
Cleaning Instructions:
Every month or two, clean both sides of the ThermoFloat blanket with ecoTUB
Spa Clean non-foaming cleaner. Rinse the blanket with a garden hose and place
it back in the spa, bubble-side down.
WARNING: Do not get on top of or swim under the floating blanket. Remove
the blanket prior to using the hot tub.
For more detailed instructions, please refer to the ThermoFloat Instruction
Manual (rev 1-13-20).
Directions for Trimming and Use
-
Using a tape measure, determine your spa’s insidesurface dimensions at the waterline.
-
Add about 2” to each dimension and record below
-
Length + 2”:
-
Width + 2”:
NOTE : Cutting the blanket about 2 inches larger helps keep it from shifting during the hot tub’s filtration cycle. -
Now lay your new ThermoFloat blanket, bubble-sidedown, onto a flat surface such as your lawn or indoorson a floor.
-
Mark the above dimensions on the smooth side of theblanket, using a marking pen.
-
Using scissors, trim to rough size, length and width.
-
Now place the roughly-trimmed ThermoFloatblanket in your filled spa, bubble-side down.
-
Using the marker, trace around rounded cornersand any other spa features requiring a cutout oradditional trimming.
-
Trim again as needed with scissors.
Cleaning
- Every month or two, clean both sides with ecoTUB Spa Clean non-foaming cleaner.
- Then rinse with a garden hose and place back in spa, bubble-side down
WARNING : Do not get on top of or swim under the floating blanket. Remove
the blanket prior to using hot tub.
© SpaDepot.com thermofloat-instructions.pdf (rev.
1-13-20)