Shada 2400547 High Bay LED Light User Guide

LED’s light Pro

****Installation

**** Disconnect power before installing the product or servicing it.
Installing LED High Bay

1. Install the hook onto the top hole and rotate it to the end
2. Fasten the screw nut tightly with wrench
3. Fasten the security screw
4. Hook the product onto the designated location and fasten the security screw tightly.
5. Make all wiring connections.
   Cap off dimming wires if not used.

Safety Instructions:

Make sure you have fully read and understood the instructions in this document before installing or using the product according to the installation Awiring diagram (if applicable). Keep this document for future use and use the product only as described in this document. Any use of the product other than as described in this manual may damage the product or injure the user (e.g., short circuit, fire, or electric shock). Disconnect the product from the power source if problems occur. Do not drop the product and avoid impacts. Do not use the product if any part is damaged or defective. Replace a damaged or defective product immediately.
If work must be done on high voltage power lines, it must be done by a qualified electrician to reduce the risk of electric shock. Ensure that the product is adequately ventilated during use. Never cover an electrical (LED) device during use as this generates heat and can cause damage. LEDs can be extremely bright and cause serious eye damage, never look directly into the light source! If a product is intended for indoor and/or outdoor use only, this is indicated on the product/components or in the manual. Keep the product out of the reach of children or animals.

**** Warranty and after-sales service:

Our Shada products are subject to strict quality standards and are regularly checked for their technical properties and functions by independent testing institutes. We provide a 60-month warranty on this product, provided it has been used, installed and maintained as intended. Full warranty terms for our Shada products and further information can be found on our homepage. If you need further assistance or have comments or suggestions, please visit www.shada.nl/nl/contact or contact us directly.

Instructions for cleaning and maintenance:

Do not use detergents or abrasives. Do not clean the inside of the device. Repairs to the product should only be performed by qualified trade personnel. Clean the outside of the device with a soft, damp cloth (do not use a microfiber cloth).

Disposal Instructions:

General information on disposal
According to the European WEEE Directive, electrical and electronic devices must not be disposed of with household waste. Their components must be recycled or disposed of separately, as they can be toxic and hazardous. Improper disposal of components may cause permanent damage to the environment. Details are regulated by the respective national legislation. The symbol on the product, operating instructions and/or packaging refers to these regulations. By separating, recycling and disposing of old appliances, you are making an important contribution to protecting our environment.
Replaceable batteries and lamps must be removed from the electrical/electronic product before returning the product(s) for recycling and must be offered separately.

Disposal instructions for

• Luminaires with replaceable light source: Remove the light source from the lamp and take the light source separately to recycling (electronic waste collection point). If both the light source and surrounding product (e.g. luminaire housing) are to be disposed of, the light source and surrounding product must be offered separately. If necessary, check whether the lamp can be repaired (e.g. by replacing the light source) to avoid unnecessary electronic waste.

• Luminaires with permanently installed light source: The light source cannot be replaced. Please recycle the entire product.

• Luminaires with separate / replaceable power supply
  If necessary, check whether the lamp can be repaired (e.g. by replacing the power supply) to avoid unnecessary electronic waste. If it is not possible to replace the power supply unit, recycle the product.

• Luminaires with integrated/non-interchangeable power supply unit: The power supply unit cannot be replaced. Please recycle the entire product.

For the environment!
In terms of sustainability, large amounts of electronic waste can be avoided by replacing light sources and other components (e.g. power supplies). Therefore, please check whether replacement light sources or other replaceable components are available. These can usually be made available to you quickly and free of charge during the warranty period.

The manual must be passed on to third parties if the complete product is passed on.

Art.-Nr.: 2400547

earth. The current will Flow in the earth conductor in case of failure.
| 1-10V dimmable.
| Do not stare at the light source.
| A high durability coating system for environmental conditions such as Chemical manufacturers, swimming baths and ship- and boatyards by the sea.
| Replaceable control gear
| Non-replaceable light source.
| IKO8 – Protected against 5 joules of impact.
| Minimum distance to illuminated objects.
| IP65-Housing – Products with IP65 are dust -ight and protected against water jets.
| IEC6C598-2-2420:3 specifies requirements for luminaires intended for use where the necessity of Limited temperature on the outer surface exists, due to the risk of thermal effects, combustion, and degradation of materials but where the risk of explosion in the atmosphere does not exist.
| The item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or Land- fill and minimize any potential negative impact on human
health and the environment.
****| This product carries the CE mark, which confirms that this product meets EU safety, health and environmental protection requirements.

Molenmakershoek 28, NL-7328 JK APELDOORN – The Netherlands » www.shada.nl

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>