Vallox 125 MV Ventilation Unit Instruction Manual

Vallox 125 MV Ventilation Unit

Product Information

• Model: Vallox 125 MV
• Type: 3765
• Document: D11316
• Valid from: 01.09.2023
• Updated: 18.09.2023

Product Usage Instructions

• Safety Warning: The unit is not intended for use by children under 8 or by persons with reduced sensory, physical, or mental capabilities, or whose lack of knowledge and experience do not ensure safe operation of the unit. Such persons can use the unit under supervision or by following the instructions of someone who is responsible for their safety. Children must be supervised and not be allowed to play with the device.
• Before starting to use the product, make sure to read and understand the user manual completely.
• Installation: Follow the instructions provided in the user manual for mounting the unit on the wall.
• Condensate Water Sealing: Use the provided condensing water sealing to ensure proper sealing of the condensate water.
• Heat Recovery Cell: The unit is equipped with a heat recovery cell. Refer to the user manual for more information on its usage and maintenance.
• Filter: The product has a filter that needs regular cleaning or replacement. Refer to the user manual for instructions on how to clean or replace the filter.
• Electrical Wiring: Internal electrical installation instructions are provided in the user manual. Follow them carefully for proper wiring.
• Safety Precautions: Always adhere to safety precautions mentioned in the user manual to avoid any accidents or injuries.
• Maintenance: Regularly check and clean the unit as instructed in the user manual to ensure optimal performance and longevity.
• Troubleshooting: In case of any issues or malfunctions, refer to the troubleshooting section of the user manual for possible solutions.

Note: This is a partial extract from the user manual. For complete information and detailed instructions, please refer to the actual user manual provided with the product.

WARNING
The unit is not intended for use by children under 8 or by persons with reduced sensory, physical or mental capabilities, or whose lack of knowledge and experience do not ensure safe operation of the unit. Such persons can use the unit under supervision, or by following the instructions of someone who is responsible for their safety. Children must be supervised and not be allowed to play with the device.

WARNING
Water must at all times be kept out of the electrical system.

IMPORTANT
If the power cord is damaged, the manufacturer, its service representative or other person with similar qualifications must replace it to avoid danger.

DANGER
Indicates a hazard that will result in death or serious injury if not avoided.

WARNING
Indicates a hazard that can result in death or serious injury if not avoided.

CAUTION
Indicates a hazard that can result in minor or moderate injury if not avoided.

MAIN PARTS

• extract fan
• supply air fan
• supply air fine filter
• heat recovery cell
• cell bypass flap
• Supply air coarse filter
• Extract air coarse filter
• Post-heating resistor
• Additional heating resistor
• Safety switch
• Internal humidity and carbon dioxide sensor
• Ceiling bushing for electric wires
• Control panel
• Carbon dioxide sensor (option)
• ENG Humidity sensor (option)
• VOC-sensor (option)

MOUNTING ON THE WALL

CONDENSING WATER SEAL

DIMENSIONS, OUTLETS

1. Supply air from the unit to the apartment
2. Extract air from the apartment to the unit
3. Exhaust air flowing outdoors from the unit
4. Outdoor air to the unit

HEAT RECOVERY CELL

FANS

FILTER

1. Supply air fine filter
2. Supply air coarse filter
3. Extract air coarse filter

FAN POWER CONSUMPTION

SUPPLY- AND EXTRACT AIRFLOWS

extract air

INTERNAL WIRING

A. Motherboard

B.

1. Extract fan tacho
2. Extract fan PWM
3. Supply fan tacho
4. Supply fan PWM

C

1. Extract air
2. Outdoor air
3. Supply air
4. Exhaust air
5. Supply air from the cell

D. LAN

MB_A
External Modbus

MB_B
External Modbus

+24V
+24V voltage (DC)

GND
Digital and analog ground potential

RS_A
Local Modbus A -signal

RS_B
Local Modbus B -signal

NTC
External temperature sensor connector

D/I1
Digital input 1

D/I2
Digital input 2

11V1
1.1 V operating voltage

AN/1
Analog input 0-10 VDC

RM/I
24 V relay input

RM/O
24 V relay output

T
Supply air fan

P
Extract air fan

M
Bypass motor

TK
Safety switch

AHS|
Post-heating control

RH%
Internal humidity sensor

%RH CO2
Internal humidity and carbon dioxide sensor

R1, R2
Post-heating resistor with 90°C and 130°C overheating protection

EXTERNAL WIRING DIAGRAM

1. MyVallox VOC sensor
2. MyVallox RH% sensor
3. MyVallox CO2 sensor
4. Remote monitoring Modbus RTU
5. External temperature sensor
6. Analog input two different functions
7. Digital input 1
8. Digital input 2
9. Potential-free relay output
10. Ethernet-connector
11. RJ45 female
12. Ventilation unit internal electrical connections
13. Plug connection 1.2 m on top of the unit
14. MyVallox control panel

DECLARATION OF CONFORMITY

ManufacturerVallox Oy
Address
Telephone number
Fax
The person who compiles the technical file
Description of unit
Model Vallox 121 SE,
Myllykylantie 9-11, FIN-32200 LOIMAA, FINLAND
+358 10 7732 200
+358 10 7732 201
Petri Koivunen
Vallox Oy
Myllykylantie 9-11, FIN-32200 LOIMAA, FINLAND
Tel. +358 10 7732 234
Fax +358 10 7732 201
Email petri.koivunen@vallox.com
Ventilation unit with heat recovery
Vallox 51/51K SC/MV,
Vallox 99/101/125/096/110/145/245/245 VKL MV,
Vallox TSK Multi 50/80 MV,
ValloPlus 180/180K/270/350/370/510/850 MV,
ValloPlus 180/270/350/510 SC,
ValloMulti 200/300 SC/MV
Declares that the ventilation unit for supply and extract air, equipped with heat recovery and operating as part
of a ventilation system has been designed and manufactured to the following specifications:

1. Low Voltage Directive (2014/35/EU) – EN 60335-1 :2012 + A 11 :2014, A 13:2017 + A1 :2919 + A14:2019 + A2:2019; EN 62233:2008
2. EMC Directive (2014/30/EU) – EN 61000-6-1 :2007, EN 61000-3-2:2014 + A 1 :2009 + A2:2009, EN 61000-3-3:2013, EN 61000-6-3:2007 + A1 :2011
3. Ecodesign Directive (2009/125/EY) – Comission regulation 1253/2014 – EN 13141-7 Annex B, EN 308, EN 13141-7, ISO 3741, ISO 5135

This is the original Declaration of Conformity
Loimaa, 7th August 2023

WARRANTY TERMS

SCOPE

• These warranty terms are applied to all products (“Products” or “the Product”) sold by Vallox Oy (“the Seller”) to its customers (“the Buyer”). Any deviations from these warranty terms must be agreed upon in writing.
• Any deviations from these warranty terms must be agreed upon in writing. These warranty terms supplement the separate contract made between the Seller and the Buyer (“the Contract”) and constitute a vital part of the said Contract. Should there be discrepancies between the Contract and these warranty terms, the terms and conditions of the Contract shall be applied instead of these warranty terms.

WARRANTY

• The Seller grants the Products a twenty-four (24) month warranty calculated from the delivery of the Product, unless the Seller and the Buyer agree otherwise. The Seller’s warranty includes the assurance that the Products comply with the Seller’s valid product specifications applied to normal trade, unless otherwise has been agreed upon by the Seller and the  Buyer in writing (“Product specifications”). The repair or replacement of a faulty product does not extend the warranty period of the Product.

• Faults include, for example, manufacturing and structural errors and other faults and defects that become evident during the warranty period and reduce the usability of the Product. However, the Seller will not be responsible for faults when the Seller can prove that the deviation in the quality or usability of the product from normal is likely to be due to a reason attributable to the Buyer. Such a reason can be, for example, non-compliance with the installation, operation, or maintenance instructions provided to the Buyer or other erroneous handling of the Product.

• When the warranty is broken, the only legal remedies available to the Buyer and the only obligations of the Seller, subject to the sole discretion of the Seller, are: (i) compensating the purchase price in exchange for the return of the faulty Product, or (ii) repairing the Product or replacing the faulty Product with a new one.
  Repairing the Product or replacing the faulty Product with a new one requires, in accordance with these warranty terms, that the Seller or the party authorised by the Seller is given access to the premises and the systems to the extent required by the warranty servicing. If this requirement is not fulfilled and the warranty servicing cannot be implemented, the Buyer will be responsible for any resulting additional expenses.

• The Buyer must inspect the Products immediately upon reception and must submit a written claim to the Seller if the Products deviate from the Product specifications or are defective in relation to the Product specifications. A claim must be submitted on deviations and defects within fourteen (14) days from the moment they were observed or should have been observed. The claim must include a complete list of the Products that the Buyer considers to be faulty and detailed photographs of the faults. The model and serial number of the Products must be specified. Before the Seller accepts the warranty claim subject to the Seller’s sole discretion, the Seller has the right to inspect the faulty Products and the operating conditions in which the defects were observed. A claim must be submitted to the Seller of any hidden defects within fourteen (14) days from the moment they were observed or should have been observed. The Buyer has the burden of proving that the defect is hidden in nature.

• The Seller will not be responsible for any other fees or expenses based on the warranty. The faulty product that has been replaced must be handed over to the possession and ownership of the Seller. If Products must be returned to the Seller, the Seller reserves the right to approve the transportation expenses beforehand.
  If Products are suspected to be faulty or to not comply with the Product specifications, even when no fault has been identified, their use is strictly forbidden.

• The Seller will not be responsible for the product or a part of the Product when a) the Product is damaged during transportation, which the Seller is not responsible for based on the delivery term; b) the Product is damaged due to an accident after delivery or due to carelessness or inappropriate storage; c) the Product is used against the installation, operation, or maintenance instructions or otherwise in an inappropriate manner, or the use of the Product is continued despite poor performance; or d) the matter concerns normal tear and wear. If the Buyer neglects the above duty of care, the Buyer will be deemed to have waved all claims they have made regarding the Products.

• If it is found during warranty repairs that the Product is not faulty or that the fault is excluded from the scope of the warranty, the Seller has the right to charge a reasonable fee for the repair visit, even when no actual repairs are implemented.

• In addition to the warranty granted based on these warranty terms or the Contract, the Seller has not given any other explicit or silent warranty regarding e.g. the suitability for commercialisation or purpose of the Product. For the sake of clarity, it is stated that this warranty does not, therefore, cover the indirect losses or damage caused to the Buyer or any losses or damage caused to third parties by the faulty Product.

www.vallox.com
Vallox Oy | Myllykyläntie 9-11 | 32200 LOIMAA | FINLAND

References

• Vallox Ordering system — Vallox-ilmanvaihtolaitteiden suodattimet
• Etusivu - Vallox
• One moment, please...

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>