POWER PROBE PPTACT1CS The Probe 12V Test Light with Haptic Feedback Instructions
- June 13, 2024
- POWER PROBE
Table of Contents
POWER PROBE PPTACT1CS The Probe 12V Test Light with Haptic Feedback
Instructions
The Probe Instructions
Connect alligator clip to positive or negative source on vehicle. When testing
for voltage or ground. Switch must be pressed. When bulb illuminates, voltage
is present. If voltage is greater than 12.0v, the bulb will illuminate and
tool will vibrate. On a good ground, the bulb will illuminate green. On a bad
ground, or a resistance of 10 to 600 Ohms, the Tool will illuminate Blue.
Installing / Replacing Battery
- Unscrew end cap of tool
- With your hand holding the tool, slide switch back and gain access to circuit board
- Install battery with negative (-) side facing the circuit board.
- Re-install switch and screw end cap of tool.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>