UTV Stereo Powersports RGB LED Controller Kit Instructions
- June 13, 2024
- UTV Stereo
Table of Contents
UTV Stereo Powersports RGB LED Controller Kit
Wiring Diagram
Instructions
Step 1 : Disconnect battery.
Step 2: Place RGB controller near the amplifier.
Step 3: Route RGB wire from the speakers to the RGB controller and
amplifier. If you do not have an amplifier, route wires to source unit.
(Reference Wire Diagram)
Step 4 : Mount “Speaker Lights” switch, route Red and Black wires (two
wires side) from harness and connect it to the RGB controller with the EZ
2-pin connector. (Reference Wire Diagram)
Step 5: Route bus bar wires (Yellow, Black, Red) from harness (three wire
side) to the factory bus bar. (Reference Wire Diagram)
Step 6: Strip off 6 inches of the black outer jacket of each set RGB
wire.
Step 7 : Strip each individual 22 AWG wire, exposing the metal
underneath. Make sure to strip enough length to fit into a butt connector.
Step 8: Bundle each 22 AWG wire with their corresponding color. (Red with
red, blue with blue, ect.)
Step 9 : Slide all 22 AWG (same colored) (4 Blue, 4 Red, 4 Black, 4
Green) wire into one end of a butt connector and crimp with a set of crimpers.
(All red wire in one connector, all blue wire in one connector, ect.)
Step 10 : Grab the 4-pin EZ connector (match with corresponding colored
EZ connector) with the stripped ends of the RGB wire. Strip more of the outer
jacket off each individual wire and feed each wire into the corresponding-
colored butt connector. Crimp each butt connector end.
Do Not Return This Product!
NEED HELP?
– Call Us 480-616-2299
– Email Us: info@utvstereo.com
– Go To Product Page On Our Website & Watch Instruction Videos
RGB Controller Set Up / Whip Set Up
-
Step 1 : Download Magic LED Light V2 in app store. SCAN QR CODE TO DOWNLOAD APP
SCAN QR CODE TO DOWNLOAD APP
-
Step 2 : Power on speakers or whips.
-
Step 3 : Select the name of your speakers within the app. Make sure to select the name within 60 seconds of powering on.
-
Step 4 : Type a custom name for your speaker or Whips.
-
Step 5: Make sure RGB & GRB are selected on “Change Device Type”.
If you have UTV Stereo whips and speaker lights, you are able to sync them together by selecting “Add Group” in the app and give it a group name.
UTV Stereo RGB Controller Kit Instructions
Compatible with all RGB compatible speakers
Need Help? Call Tech Support: (480)-616-2299
Email: info@utvstereo.com
Go to utvstereo.com for colored installation pictures
& YouTube videos.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>